Author Topic: 357 ??  (Read 458 times)

0 Members and 2 Guests are viewing this topic.

Offline GameHauler

  • Trade Count: (49)
  • A Real Regular
  • ****
  • Posts: 867
  • Gender: Male
  • Thank you Every One for Positive Feedback
357 ??
« on: July 06, 2008, 10:00:58 AM »
Loading up some 357 magnum loads and have a question.

I will be using Bulleye because I have 3# of it.
I went to Alliants web site and they show a charge of 9 grains.
I look in the Lyman manual and the show a start load of 7 grains
with a max of 9.7
what do you think? Go with Alliants 9 grains

Oh ya! 110 gr JHP

Mike
Mike

Offline Graybeard

  • Administrator
  • Trade Count: (69)
  • Senior Member
  • *****
  • Posts: 26939
  • Gender: Male
Re: 357 ??
« Reply #1 on: July 06, 2008, 10:48:43 AM »
I learned long ago when I used my S&W Model 19 in competition that 6.5 grains of Bullseye and a Hornady 125 grain bullet was as accurate a load as I could find in the .357 Magnum. It's not a max load by any means but is fast enough to do anything a 125 grain will do and has been very accurate in every .357 Magnum gun I've owned since.

If I were you I'd stop worrying about max loads and find an accurate one. I suspect that's gonna come at less than maximum powder charge.


Bill aka the Graybeard
President, Graybeard Outdoor Enterprises
256-435-1125

I am not a lawyer and do not give legal advice.

Jesus is the way, the truth, and the life anyone who believes in Him will have everlasting life!

Offline GameHauler

  • Trade Count: (49)
  • A Real Regular
  • ****
  • Posts: 867
  • Gender: Male
  • Thank you Every One for Positive Feedback
Re: 357 ??
« Reply #2 on: July 06, 2008, 11:01:00 AM »
Thanks Graybeard.
I am not trying to get max loads,
I am just getting my feet wet with the components I have on hand.
I was mostly confused as why there was 2 grains difference.

I am guessing that since Alliant does not list a start load or max
that they have found 9 grains to be the all around best and safe.
Thanks again,
Mike
Mike

Offline stimpylu32

  • Moderators
  • Trade Count: (67)
  • Senior Member
  • *****
  • Posts: 6062
  • Gender: Male
Re: 357 ??
« Reply #3 on: July 06, 2008, 11:41:42 AM »
GH

If you read the last few lines in this link , you will see were Alliant says to reduce their data by 10% for a starting load , So 9gr vs 9.7gr is not that far off .

http://www.alliantpowder.com/reloaders/Index.htm

Also as Bill said , you will in most cases find the sweet spot well before MAX .  ;D

stimpy
Deceased June 17, 2015


:D If i can,t stop it with 6 it can,t be stopped

Offline GameHauler

  • Trade Count: (49)
  • A Real Regular
  • ****
  • Posts: 867
  • Gender: Male
  • Thank you Every One for Positive Feedback
Re: 357 ??
« Reply #4 on: July 06, 2008, 11:55:19 AM »
Thanks Stimpy.
The way I read that is I should be starting with 8.1

I had read that before but it was swimming around
in the murky waters of all the info I am trying to ingest.
Mike

Offline jhalcott

  • Trade Count: (1)
  • Senior Member
  • *****
  • Posts: 1869
Re: 357 ??
« Reply #5 on: July 06, 2008, 04:01:10 PM »
my old Speer #11 manual ,page 406, has 7.5 minimum and 8.5 maximum with the 110HP. The gun used is a 6" Security Six!
  Always start low and work up!

Offline Savage

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 4397
Re: 357 ??
« Reply #6 on: July 07, 2008, 05:49:45 AM »
If you're looking for accuracy, I'd start down at 6.5 grs like Graybeard suggested. If the load proves accurate in your gun, you'll load about 300 more rounds per pound of powder, and save some wear on you and your gun.
Savage
An appeaser is one who feeds the crocodile hoping it will eat him last,