« previous next »
Pages: [1]   Go Down

Author Topic: another newbie question  (Read 239 times)

0 Members and 1 Guest are viewing this topic.

Offline jw83

  • Trade Count: (5)
  • Member
  • *
  • Posts: 61
another newbie question
« on: September 07, 2008, 02:32:08 PM »
I'm loading .44 special rounds and my manual's MIN OAL seating depth for my bullet will put the cannelure outside of the crimp. My question is should I seat the bullet acording to manual specs or should I always crimp in the cannelure?
Logged

Offline stimpylu32

  • Moderators
  • Trade Count: (67)
  • Senior Member
  • *****
  • Posts: 6062
  • Gender: Male
Re: another newbie question
« Reply #1 on: September 07, 2008, 02:39:26 PM »
jw

You do not have to crimp at the cannelure in most cases , but when using platted or thin jacketed bullets its a good idea to use them as sometimes the crimp will cut the jacket or platting and leave it in the barrel when the bullet is fired .

A lot of bullets don't even have a cann to crimp at .

stimpy
Logged
Deceased June 17, 2015


:D If i can,t stop it with 6 it can,t be stopped

Offline jw83

  • Trade Count: (5)
  • Member
  • *
  • Posts: 61
Re: another newbie question
« Reply #2 on: September 07, 2008, 02:57:52 PM »
I'm using Nosler JHP so I guess I better stick with the cannelure.
Logged
Pages: [1]   Go Up
« previous next »