« previous next »
Pages: [1]   Go Down

Author Topic: Ejector problems  (Read 347 times)

0 Members and 2 Guests are viewing this topic.

Offline sonofafish

  • Trade Count: (1)
  • Avid Poster
  • **
  • Posts: 168
  • Gender: Male
Ejector problems
« on: September 12, 2008, 12:45:20 PM »
I have an older H&R 30/30 and with reloads I can not get them to eject, but on factory loads it works all the time.Is it my dies or what?
Logged

Offline quickdtoo

  • Global Moderator
  • Trade Count: (149)
  • Senior Member
  • *****
  • Posts: 43301
  • Gender: Male
Re: Ejector problems
« Reply #1 on: September 12, 2008, 02:14:31 PM »
You can improve ejector function, see the FAQs.  ;) What's the load data you're using that's causing the sticking?

Tim
Logged
"Always do right, this will gratify some and astonish the rest" -  Mark Twain

Offline sonofafish

  • Trade Count: (1)
  • Avid Poster
  • **
  • Posts: 168
  • Gender: Male
Re: Ejector problems
« Reply #2 on: September 12, 2008, 03:09:46 PM »
Tim, the loads are      Hornady 168 a max n135 27 gr
                               speer 150 bt n135 26.5 27 gr
                                Hornady 150 amax n135 26 gr
                                rem. 150silver tip n135 26.5
Logged

Offline quickdtoo

  • Global Moderator
  • Trade Count: (149)
  • Senior Member
  • *****
  • Posts: 43301
  • Gender: Male
Re: Ejector problems
« Reply #3 on: September 12, 2008, 03:54:55 PM »
I'd polish the chamber and tune the ejector as shown in the FAQs and give it a shot.  ;)

Tim
Logged
"Always do right, this will gratify some and astonish the rest" -  Mark Twain

Offline sonofafish

  • Trade Count: (1)
  • Avid Poster
  • **
  • Posts: 168
  • Gender: Male
Re: Ejector problems
« Reply #4 on: September 13, 2008, 09:59:03 AM »
Tim, thank you for the help I will get on it soon.
Logged
Pages: [1]   Go Up
« previous next »