« previous next »
Pages: [1]   Go Down

Author Topic: target metal type ??  (Read 637 times)

0 Members and 1 Guest are viewing this topic.

Offline hunt4570

  • Trade Count: (13)
  • A Real Regular
  • ****
  • Posts: 604
  • Gender: Male
    • Harley FLT?FLH bikes and Rides
target metal type ??
« on: August 02, 2003, 07:44:14 AM »
I had a friend make me some (square)sillouttes out of 3/8 & 5/8 steel plate,they are diveting pretty bad.what type of metal would not divet sooo bad????? :?
Logged
PETA.....P eople  E ating  T asty  A nimals

  Come visit my forum  http://forums.delphiforums.com/anyride/start

Offline Smokin7mm

  • Trade Count: (0)
  • Member
  • *
  • Posts: 71
target metal type ??
« Reply #1 on: August 04, 2003, 07:57:50 AM »
typically targets for silhouette are made from T-1 steel.  Mild steel will crater depending on cartridge and velocity.  T-1 is much more durable.
Logged

Offline Monty

  • Trade Count: (0)
  • Posts: 4
target metal type ??
« Reply #2 on: August 04, 2003, 01:03:14 PM »
I've got a origional steel chicken from Angeles Range Matches

  Back in the 70's we used armor plate however even with that a

 30-06 B.T. will pierce it. A .458 solid will make a big creator and

a 44 mag leaves a little mark. :-D In the late 70's the base was big

they were tilted forward and a seventy mile wind wouldn't bother them

More than I could count I've bounced Full Bore 44's off the Rams and

turkeys and they just  :-D  :)  :-D  :)
Logged
I shot the first IHMSA Match ever held.
Enjoy Hunting Fishing and Reloading
Life Member NRA
IHMSA Member #000144
Pages: [1]   Go Up
« previous next »