527

[jeclif]

hey next time you clean your 527 look and tell me if you have 1 or 2 sleeves on the bolts that hold the trigger guard  --one on each bolt(screw)
I think I lost one    When I screw them tight the mag. hangs but if the one on the
barrel end  is not tight it works good.

[Skunk]

jeclif,

I don't have a 527 to look at for you, but, I did look in the Instruction manual for the 527, and it shows that the rear frame screw (part #70) is the only frame screw that has a spacer (part #68). The front frame screw (part #69) has NO spacer according to the diagram.

I was surprised to see this on the 527 because the 550 does have a spacer on each screw.

You can download a manual for the 527 at http://www.cz-usa.com/support_downloads.php 

Note: It appears they (CZ) are having tech problems with their site as I type this message, so just keep trying if the link gives you an error message.

[FourBee]

  Hey jeclif; Skunk is correct.  My CZ527 only has one trigger guard spacer located at the rear.   I found that re-assembly of the 527 is difficult.   Maybe I just need more practice at it, but my patience wears pretty thin.

[jeclif]

tell me about it
I love the gun but the mag latch spring is another thing
anyone have one of the 223's in 1 in 9 twist barrels?
what does it like best  bullet weight wise??
I am thinking of getting another  527

[Badnews Bob]

I have one and it will shoot anything I've put thru it well up 69grs haven't tried heavier.

[FourBee]

tell me about it
I love the gun but the mag latch spring is another thing

My sentiments too......................................