« previous next »
Pages: [1]   Go Down

Author Topic: AR stock change  (Read 431 times)

0 Members and 1 Guest are viewing this topic.

Offline blackwolfe

  • Trade Count: (0)
  • Member
  • *
  • Posts: 73
AR stock change
« on: December 03, 2008, 09:11:44 PM »
What is needed to change out a solid AR stock to a 4 or 6 position stock?  What tools are needed?  Any recommended brands of tools and stocks?
Logged
wolfe

Offline Totenkopf

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 215
Re: AR stock change
« Reply #1 on: December 04, 2008, 01:32:09 PM »
Removal is pretty straight forward. Push in rear take down pin. Pivot upper half forward. Push down spring loaded boss at rear of lower receiver, directly in front of buffer with spoon. Remove buffer and spring from stock. Use this to unscrew butt stock nut.
http://www.midwayusa.com/eproductpage.exe/showproduct?saleitemid=115742
Or better yet buy armorers tool if you are planning on removing barrel in future.
http://www.midwayusa.com/eproductpage.exe/showproduct?saleitemid=271183
 Install colapsable stock. Put in new spring and buffer from inside lower receiver.
I like magpul, but tapco, dpms, bushmaster, CAA, Advanced Technology or any other name brand are fine.
http://www.midwayusa.com/eproductpage.exe/showproduct?saleitemid=910076&t=11082005





Logged
U.S. Army Retired
1st SFOD-D
Fort Bragg, NC

John 10:10

 The thief cometh not, but for to steal, and to kill, and to destroy: I am come that they might have life, and that they might have it more abundantly.
Pages: [1]   Go Up
« previous next »