« previous next »
Pages: [1]   Go Down

Author Topic: 1894 saddle ring...  (Read 857 times)

0 Members and 1 Guest are viewing this topic.

Offline Lanny

  • Trade Count: (0)
  • Member
  • *
  • Posts: 24
1894 saddle ring...
« on: December 11, 2008, 02:04:53 PM »
I took the saddle ring off of my 1894 and would like to know if somebody can tell me
what the plug size is for the hole.....The thread and pitch...?..Thanks..
Logged
"The problem with socialism is that eventually you run out of other people’s money."

Offline Rangr44

  • Trade Count: (6)
  • Senior Member
  • *****
  • Posts: 2158
Re: 1894 saddle ring...
« Reply #1 on: December 11, 2008, 02:41:09 PM »
It depends upon the DOM of your rifle, as Winchester 94's were made with two different hole/thread sizes, large/small, for the saddle rings.

MidwayUSA might still sell the plug screws, as I've bought them there, previously.

.
Logged
There's a Place for All God's Creatures - Right Next to the Potatoes & Gravy ! !

Offline Lanny

  • Trade Count: (0)
  • Member
  • *
  • Posts: 24
Re: 1894 saddle ring...
« Reply #2 on: December 14, 2008, 06:17:35 AM »
 :) Found the answer...Post 64 is... 8-40....pre 64 is 1/4-30.. :)
Logged
"The problem with socialism is that eventually you run out of other people’s money."

Offline trotterlg

  • GBO Supporter
  • Trade Count: (36)
  • Senior Member
  • *****
  • Posts: 3978
  • Gender: Male
Re: 1894 saddle ring...
« Reply #3 on: December 15, 2008, 03:41:24 PM »
8-40 is a screw size used by some scope base mounts, that will probably be easier than finding a 1/4 30.  A 1/4 28 that is very short may well go in two threads before it gets tight and be just right.  Larry
Logged
A gun is just like a parachute, if you ever really need one, nothing else will do.
Pages: [1]   Go Up
« previous next »