« previous next »
Pages: [1]   Go Down

Author Topic: Fore end for a topper deluxe barrel  (Read 413 times)

0 Members and 1 Guest are viewing this topic.

Offline tireman

  • Trade Count: (6)
  • Member
  • *
  • Posts: 73
Fore end for a topper deluxe barrel
« on: January 18, 2009, 03:43:05 AM »
I have a 20 barrel n topper deluxe and a standard fore am does not fit.  Tell me what i need Thanks Clark
Logged

Offline MSP Ret

  • GBO Supporter
  • Trade Count: (173)
  • Senior Member
  • *****
  • Posts: 8940
  • Gender: Male
Re: Fore end for a topper deluxe barrel
« Reply #1 on: January 18, 2009, 07:53:35 AM »
It should fit. Perhaps if you explain in a bit more detail what you mean by it does not fit someone here can help....<><....:)
Logged
"Giving up your gun to someone else on demand is called surrender. It means that you have given up your ability to protect yourself to a power that is greater than you." - David Yeagley

Offline tfranklin7

  • GBO Supporter
  • Trade Count: (163)
  • Contributor
  • *****
  • Posts: 408
  • Gender: Male
Re: Fore end for a topper deluxe barrel
« Reply #2 on: January 18, 2009, 01:24:33 PM »
I had the same problem with a 20ga. Topper barrel I  bought . I know your forend  is for a Deluxe Topper but look a the thread below and see the pics. If this is your problem you may get a 20 ga.Topper Deluxe forend at
www.e-gunparts.com , The Topper uses a different forend for 20,28,32 and .410.

http://www.gboreloaded.com/forums/index.php/topic,160109.0.html
Logged
"A government big enough to give you everything you want, is big enough to take away everything you have." - Thomas Jefferson

Offline tireman

  • Trade Count: (6)
  • Member
  • *
  • Posts: 73
Re: Fore end for a topper deluxe barrel
« Reply #3 on: January 18, 2009, 01:32:18 PM »
The topper deluxe barrel does not taper like the other barrels. This is a new vent rib barrel with screw in chokes.   Thanks Clark
Logged

Offline quickdtoo

  • Global Moderator
  • Trade Count: (149)
  • Senior Member
  • *****
  • Posts: 43301
  • Gender: Male
Re: Fore end for a topper deluxe barrel
« Reply #4 on: January 18, 2009, 02:01:31 PM »
You'll need to flair the barrel channel near the spacer for the TDC barrel, I had to do that to fit a synthetic forend to the TDC barrel I bought from MSP, just sand it until it fits, you'll see where it binds when you try to install it. You can also order the checkered TDC forend from H&R or Brownell's.

Tim
Logged
"Always do right, this will gratify some and astonish the rest" -  Mark Twain

Offline tireman

  • Trade Count: (6)
  • Member
  • *
  • Posts: 73
Re: Fore end for a topper deluxe barrel
« Reply #5 on: January 18, 2009, 07:50:24 PM »
Thanks for the info Qiuck you are good at this.  Clark
Logged
Pages: [1]   Go Up
« previous next »