« previous next »
Pages: [1]   Go Down

Author Topic: Taurus 941 ..22 mag.  (Read 1194 times)

0 Members and 1 Guest are viewing this topic.

Offline ironglow

  • GBO Supporter
  • Trade Count: (9)
  • Senior Member
  • *****
  • Posts: 31342
  • Gender: Male
Taurus 941 ..22 mag.
« on: February 02, 2009, 02:05:24 PM »
  Want to start carrying more often. I have a Taurus 941 in .22 Mag. I want to carry concealed, but it has a 4" barrel and wood grips.
  I expect I can swap someone for rubber grips...but a 4" barrel.??
  How tough is it to put a 2" barrel on it in place of the 4" barrel? Is a costly set of parts required?  Anyone here ever done it ?
Logged
If you don't want the truth, don't ask me.  If you want something sugar coated...go eat a donut !  (anon)

Offline Cottonwood

  • Moderator
  • Trade Count: (5)
  • Senior Member
  • *****
  • Posts: 2780
  • Gender: Male
  • "Capturing the moment, to last a lifetime"
Re: Taurus 941 ..22 mag.
« Reply #1 on: February 03, 2009, 11:20:28 AM »
Quote from: ironglow on February 02, 2009, 02:05:24 PM
  Want to start carrying more often. I have a Taurus 941 in .22 Mag. I want to carry concealed, but it has a 4" barrel and wood grips.
  I expect I can swap someone for rubber grips...but a 4" barrel.??
  How tough is it to put a 2" barrel on it in place of the 4" barrel? Is a costly set of parts required?  Anyone here ever done it ?

Don't quote me on this, but your barrel should come off just like a S&W, and BTW the 22 Mag makes a real hard hitter up close and personal like.  I had several friends that worked very undercover and because the 22 Mag was so small and flat in the little 2 shot High Standard they said the round was devistating a belly gun.
Logged

Offline ironglow

  • GBO Supporter
  • Trade Count: (9)
  • Senior Member
  • *****
  • Posts: 31342
  • Gender: Male
Re: Taurus 941 ..22 mag.
« Reply #2 on: February 04, 2009, 12:54:15 AM »
Montanan,
   Thanks, but since I am more "rifle" than "handgun"..I'm not even sure how a S&W is replaced. Picture shows threads, but are shims or some other method used to assure sight alignment and cylinder gap?
  BTW: Does using crocus cloth in the cylinder to polish, sound like a good way to stop the empties from hanging so firmly? As I said, I have only run about a full box of rounds through it and that Winchester Supremes. Perhaps regular 40gr, less hyper rounds would chamber better..
Logged
If you don't want the truth, don't ask me.  If you want something sugar coated...go eat a donut !  (anon)
Pages: [1]   Go Up
« previous next »