I understand what you are saying GB but let me elaborate a bit more.
Since they are discontinued I have not found out allot about them but
here is what I am thinking and please tell me if I am wrong.
The bullets were built with a thinner jacket so they would expand easier
at the lower velocities of a hand gun.
So they are somewhat similar in design to a Berger VLD (jacket only)
I have not seen much about the Bergers on this site so let me elaborate just a little.
The Berger VLD was developed for long range match shooting but turned out to be an exceptional hunting bullet.
The VLD (Very Low Drag) because of it design is extremely flat shooting and has
a high BC but because of its jacket design it travels about 2" into the animal and then has a rapid expantion, expending all of the energy into the animal and not the bank or tree behind the animal.
This is especialy true with a high shoulder shot.
Most critters are slammed to the dirt and never move.
Now I know this goes against what most folks are used to for a hunting bullet
And the debate continues on a daily bases about it but I have personally see the devastation that they cause.
Small entry with little meat lose but turns all the vitals into jello and less meat loss since they do not exit most of the time.
Anyway back to the SSP's.
If I am correct about their design they should preform in the same way.
As I stated before if I was going to do a set up where the shot would be under 100yds I would take my Contender in a pistol configuration.
Most shots here are in excess of 200yds (sometimes allot) and that is why we have scopes with turrets and any ethical hunter practices ALOT at extended ranges.
I hope that makes since to ya all, Different set of rules here
Mike