« previous next »
Pages: [1]   Go Down

Author Topic: small rust spot on cylinder rod shroud  (Read 602 times)

0 Members and 1 Guest are viewing this topic.

Offline oldfart

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 138
small rust spot on cylinder rod shroud
« on: May 02, 2009, 05:03:05 PM »
i just got a charter undercover, have shot it and it shoots great. when i went to clean it i noticed a little light spot of rust inside the cylider rod shroud. how can i remove it?, i have tried soaking in oil and using a q-tip but it won't all come out. is there anything else i can do?, its not bad but i would like it out. thanks for any help.
Logged

Offline spruce

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 2248
  • Gender: Male
Re: small rust spot on cylinder rod shroud
« Reply #1 on: May 03, 2009, 03:37:46 AM »
Use a piece of #0000 steel wool wrapped around your Q-tip and your cleaning solvent or something like Breakfree CLP and lightly scrub it.  Should take the light rust off and won't hurt the bluing if you don't get carried away with the scrubbing.
Logged

Offline rpharder

  • Trade Count: (6)
  • Member
  • *
  • Posts: 83
Re: small rust spot on cylinder rod shroud
« Reply #2 on: May 14, 2009, 02:07:51 AM »
Try some FLITZ metal polish. Will not hurt factory bluing.
Logged

Offline Savage

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 4397
Re: small rust spot on cylinder rod shroud
« Reply #3 on: May 14, 2009, 07:40:01 AM »
Flitz works good to protect blued finishes as well, ---------But, I have found that car was works just as well and wayyyyy cheaper.
Savage
Logged
An appeaser is one who feeds the crocodile hoping it will eat him last,

Offline oldfart

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 138
Re: small rust spot on cylinder rod shroud
« Reply #4 on: May 15, 2009, 04:57:34 PM »
its a s.s. gun, but its now the problem for my gun shop. i traded it and a police undercover for a sp101.
Logged

Offline kiddekop

  • Trade Count: (0)
  • Contributor
  • ***
  • Posts: 280
Re: small rust spot on cylinder rod shroud
« Reply #5 on: May 15, 2009, 06:20:12 PM »
Quote from: oldfart on May 02, 2009, 05:03:05 PM
i just got a charter undercover, have shot it and it shoots great. when i went to clean it i noticed a little light spot of rust inside the cylider rod shroud. how can i remove it?, i have tried soaking in oil and using a q-tip but it won't all come out. is there anything else i can do?, its not bad but i would like it out. thanks for any help.
SS will rust that's why I use TREWAX on my blued and SS weapons
Logged
Pages: [1]   Go Up
« previous next »