Author Topic: Forcing cone angles  (Read 640 times)

0 Members and 1 Guest are viewing this topic.

Offline Kmrere42

  • Trade Count: (2)
  • Contributor
  • ***
  • Posts: 305
Forcing cone angles
« on: May 06, 2009, 09:38:11 AM »
Hi,


Simple question I think,

Are forcing cone angles measured by total angle or per side. I want to make up a tool to clean and polish my ruger and a Uberti.

I believe Rugers cone is 18 Degree's but I am not sure of the Uberti.



Paul


Offline Roper1952

  • Trade Count: (0)
  • Member
  • *
  • Posts: 21
  • Gender: Male
Re: Forcing cone angles
« Reply #1 on: May 06, 2009, 02:41:04 PM »
I'm not sure how it's measured, but 8 degrees is optimal for jacketed bullets, 11 degrees is optimal for lead.
"...a backbone is better than a wishbone..." Paul Thorn

Offline crabo

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 138
Re: Forcing cone angles
« Reply #2 on: May 13, 2009, 06:12:27 PM »
kill 2 birds with one stone and firelap it instead.  You will smooth the forcing cone and the barrel at the same time.

Offline Hank08

  • Trade Count: (35)
  • A Real Regular
  • ****
  • Posts: 887
Re: Forcing cone angles
« Reply #3 on: May 14, 2009, 05:08:44 AM »
All mine are cut to 11 degrees.  Brownell's sells the tools, simple to do.  I hardly ever shoot jacketed bullets but 11 degrees seems to work well with them too.
H08

Offline Tom C.

  • Trade Count: (0)
  • Contributor
  • ***
  • Posts: 382
Re: Forcing cone angles
« Reply #4 on: May 14, 2009, 06:59:12 AM »
In the past I cut my .44s and .45 to 11 degrees, and my .357s to 5 degrees. I now cut everything to 5 degrees.
Tom