Author Topic: New hunting knife  (Read 1022 times)

0 Members and 1 Guest are viewing this topic.

Offline Chappers

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 124
  • Gender: Male
New hunting knife
« on: May 08, 2009, 08:12:36 PM »

I just picked up this knife last week, its made by Kizlyar and i got to say it fits in my hand very well. I have not used it yet because i have not had a chance to go hunting (still setting up my new rifle) but i can see that this knife will be a welcomed addition to my hunting gear.

Offline Joel

  • Moderator
  • Trade Count: (0)
  • A Real Regular
  • *****
  • Posts: 933
Re: New hunting knife
« Reply #1 on: May 09, 2009, 05:22:15 PM »
Useful looking blade.  Apparently it's in 440C which is an excellent steel if it's been Heat Treated properly.

Offline Chappers

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 124
  • Gender: Male
Re: New hunting knife
« Reply #2 on: May 11, 2009, 04:30:55 AM »
I don’t know much about steel (i guess that 440C is from some sort of grading system?)but it’s got a nice edge (as factory edges go, i can trim my beard with it). Plus i don’t mind the look of it but the true test will be when i go and see if it useful.

Offline udtjim

  • Trade Count: (0)
  • Member
  • *
  • Posts: 35
Re: New hunting knife
« Reply #3 on: May 15, 2009, 01:04:16 PM »
Very interesting design. Let us know how it works when the time comes.

Offline Chappers

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 124
  • Gender: Male
Re: New hunting knife
« Reply #4 on: August 14, 2009, 01:38:17 PM »
Just came back from a small hunting trip,
for the story look for the topic “sneaked a bit of hunting into my holidays” in the Australia  & Pacific section

turned out to be a very good knife to skin and to strip down a carcass, all i had to do was run it over the diamond steel a couple of time and it was set to go.

I also bought a folding knife from the same company just for a everyday knife too.