I used the 130-grain Hornady Interlock for years. I like them.
This one was removed from a mule deer taken around 145-yards. Bullet hit behind the shoulder on one side and penetrated the shoulder on the opposite side, and then travelled down the leg. The recovered bullet weighs 84-grains.
This buck was shot at close range with the Hornady 130-grain. The bullet in the chest knocked him down. He stood up bleeding out of the nose, and I took a follow-up shot to the neck. He was not going anywhere, I wanted to end it.
This large antelope was at over 250-yards. I did not recover the bullet. There was a large exit hole.
Years ago I started loading 150-grain bullets for my Remington M760 in .270 Winchester. I like the results better than the 130-grain bronze point, and 130-grain C-L. I rate the Hornady 130-higher than either one of those. The 130-grain C-L is better than the bronze point.
I know longer load 130-grain bullets for the .270 Winchester. While the M760 was my 150-grain rifle, my Savage 110CL was my 130-grain rifle. It is now my 140-grain rifle. My 140-grain load is flatter shooting at long range, and at close range it offers better penetration. I have got bang flops with all three bullets weights when hitting the CNS.
If I was gearing up for a hunt and I only had 130-grain bullets to choose from in my stock, which has Remington, Nosler, Sierra, and Speer 130-grain bullets in it, my choice would be the 130-grain Hornady. My normal 130-grain load is pushed by 60-grains of H4831 or 60.5 grains of WW785. (WW785 is discontinued)