Me ejector holder trigger thingo is broked!!!!!
Can it be successfully brazed it with silver solder to fix 'er up???
I got some good stuff that is good for plug'n holes up but can get some more fluidy stuff if needed that'll run easier.
I was just wondering if it'd buggar up the temper or melt or fall apart anyway with the sintered iron / steel /monel used to make it.
Don't want a unusable blob when done.
Don't know how long the spring will keep in situ before it decidesto ecsape out of its housing.
Can I some how "tie it up with wire just to keep the show on the road"
Any help
Appreciated
Bruce
