« previous next »
Pages: [1]   Go Down

Author Topic: Fitting SAA grips?  (Read 383 times)

0 Members and 1 Guest are viewing this topic.

Offline R. Tillery

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 114
Fitting SAA grips?
« on: September 26, 2003, 07:48:02 AM »
How difficult is it to fit a set of 1-piece ivory polymer grips to an SAA clone? I've 'handled' knives, but never put grips on a pistol before. Are there any websites that could guide me through the process? TIA
Logged
'I hope that's not my ivory-handled Colt your fingers are ticklin'!'

Offline gunnut69

  • Moderators
  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 5005
Fitting SAA grips?
« Reply #1 on: September 26, 2003, 09:38:14 AM »
I know of no site to walk you thru this project..  It is a simple exercise in precision inletting.  The 1 piece grips presuppose a 2 piece grip frame...  some of the clones use a 1 piece grip frame.
Logged
gunnut69--
The 2nd amendment to the constitution of the United States of America-
"A well regulated militia, being necessary to the security of a free state, the right of the people to keep and bear arms, shall not be infringed."
Pages: [1]   Go Up
« previous next »