« previous next »
Pages: [1]   Go Down

Author Topic: jug choke  (Read 523 times)

0 Members and 1 Guest are viewing this topic.

Offline woodsrunner

  • Trade Count: (6)
  • Avid Poster
  • **
  • Posts: 105
  • Gender: Male
jug choke
« on: August 08, 2009, 04:22:45 AM »
Hello to all--has anyone here jug choked a .410?  I think mine would be a lot "handi"er with a 18" barrel. How did you do it, with what results? I just don't want to spend the money to get screw in chokes. Thanks--woodsrunner
Logged
Good Hunting--Woodsrunner

Offline SHOOTALL

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 23836
Re: jug choke
« Reply #1 on: August 08, 2009, 04:40:54 AM »
hone out a section a couple inches back from the muzzle . the approach and leaving sections will need to be ramped to faclitate the flow thru. the bbl.
you might do it with emery cloth and a wooden dowel in a drill if careful . hone a little and try it as it is a game of thousants not a deep cut .
Logged
If ya can see it ya can hit it !

Offline spooked

  • Trade Count: (5)
  • A Real Regular
  • ****
  • Posts: 515
  • Gender: Male
Re: jug choke
« Reply #2 on: August 08, 2009, 11:46:15 AM »
I think the correct procedure involed pouring a lead plug with  valve grinding paste or similar embedded in the plug.is a game of trial and trial...grind very little try for results a lot..Knowing when to quit would play a big part also..IMO  ;)
Logged
Lost between sunrise and sunset yesterday-one golden hour...never to be found or reclaimed:-(

Offline SHOOTALL

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 23836
Re: jug choke
« Reply #3 on: August 10, 2009, 03:34:56 AM »
There are hones made to do this if you want the expence . A dowel with the cloth wrapped around is an inexpensive way . The lead would be better for lapping a bore IMHO .
Logged
If ya can see it ya can hit it !
Pages: [1]   Go Up
« previous next »