« previous next »
Pages: [1]   Go Down

Author Topic: ejector question  (Read 351 times)

0 Members and 1 Guest are viewing this topic.

Offline mtbugle

  • Trade Count: (32)
  • Contributor
  • ***
  • Posts: 355
  • Gender: Male
ejector question
« on: September 23, 2009, 07:50:20 AM »
working on my 357 stub project I removed material in barrel to fit ejector using my model 158 22 jet ejector as a guide. Last night I went to order the 357 ejector and ejector latch because it has a pin hole broken out. Brownells lists the ejector as post 98. Does anyone know if the post 98 is of different or same dimensons as the older ejectors? I hope not diff as I have already removed metal to fit older style.
Thanks Don.
Logged

Offline trotterlg

  • GBO Supporter
  • Trade Count: (36)
  • Senior Member
  • *****
  • Posts: 3978
  • Gender: Male
Re: ejector question
« Reply #1 on: September 23, 2009, 08:27:41 AM »
The old style ejector is about .200 deep and the new type is about .130 deep.  In a pinch the new will work in the old, but it is nice to use the one that fills the hole.  Larry

Logged
A gun is just like a parachute, if you ever really need one, nothing else will do.

Offline mtbugle

  • Trade Count: (32)
  • Contributor
  • ***
  • Posts: 355
  • Gender: Male
Re: ejector question
« Reply #2 on: September 23, 2009, 10:34:21 AM »
I was a little afraid of that. Perhaps a bit of JB weld to bild up the size on new extractor would be better than leaving unsuported area around case. I knew I should have ordered parts first. Thanks Larry for your answer and would liked to hear your opinion on filling space. The broken extractor that I have looks like cast or pot metal in break, so I'm sure one can not build up with weld and then file down.
Thanks Don.
Logged

Offline trotterlg

  • GBO Supporter
  • Trade Count: (36)
  • Senior Member
  • *****
  • Posts: 3978
  • Gender: Male
Re: ejector question
« Reply #3 on: September 23, 2009, 11:36:38 AM »
The case isn't supported by the ejector in any case.  I would just order the pre 98 ejector and have it proper.  I would not bother building anything up, it will not make any difference to function.  Personally I would buy this one to use.  http://www.brownells.com/.aspx/pid=7020/Product/EJECTOR__1987_98 Larry
Logged
A gun is just like a parachute, if you ever really need one, nothing else will do.

Offline quickdtoo

  • Global Moderator
  • Trade Count: (149)
  • Senior Member
  • *****
  • Posts: 43301
  • Gender: Male
Re: ejector question
« Reply #4 on: September 23, 2009, 12:16:01 PM »
From previous discussions the general thought is they're made of sintered metal, I know they're hard and are much easier to machine after being annealed, I've modified a few for conversions and they seem to be pretty hard stuff and they have been known to break, at least one member closed the action on a chamber lock and broke the post off the extractor.  :-\

Tim
Logged
"Always do right, this will gratify some and astonish the rest" -  Mark Twain
Pages: [1]   Go Up
« previous next »