« previous next »
Pages: [1]   Go Down

Author Topic: Nickel cartridges  (Read 386 times)

0 Members and 1 Guest are viewing this topic.

Offline GH1

  • Trade Count: (1)
  • A Real Regular
  • ****
  • Posts: 939
  • Gender: Male
Nickel cartridges
« on: October 12, 2009, 12:18:18 PM »
I noticed one of the nickel cases I reloaded had the plating peel off after firing.  There were no signs of excessive charging, nor were any other cases affected.  Does this sort of thing happen with nickel cases?  Is it due to repeated stretching & resizing?
GH1 :)
Logged
I owe my life to an organ donor

Offline Graybeard

  • Administrator
  • Trade Count: (69)
  • Senior Member
  • *****
  • Posts: 26946
  • Gender: Male
Re: Nickel cartridges
« Reply #1 on: October 12, 2009, 12:22:53 PM »
I wish I could buy some cartridges for a nickel anymore.  ;D

I've seen folks report such peeling of the plating so I'm sure it happens but in all the thousands and thousands of nickel plated cases I've used some until I wore the plating almost completely off I've never yet seen one peel like that so I have to conclude it isn't all that comon.
Logged


Bill aka the Graybeard
President, Graybeard Outdoor Enterprises
256-435-1125

I am not a lawyer and do not give legal advice.

Jesus is the way, the truth, and the life anyone who believes in Him will have everlasting life!

Offline stimpylu32

  • Moderators
  • Trade Count: (67)
  • Senior Member
  • *****
  • Posts: 6062
  • Gender: Male
Re: Nickel cartridges
« Reply #2 on: October 12, 2009, 12:26:47 PM »
I've had it happen a few times with pistol cases , mostly its when I over bell the case mouth and give it a roll crimp , tends to crack and flake at the mouth . as for rifle brass I have not had it happen yet .

stimpy
Logged
Deceased June 17, 2015


:D If i can,t stop it with 6 it can,t be stopped

Offline huntswithdogs

  • Trade Count: (1)
  • A Real Regular
  • ****
  • Posts: 999
Re: Nickel cartridges
« Reply #3 on: October 13, 2009, 09:00:00 AM »
I've got some older Remington cses that have flaked off some but it hasn't hurt the cases. I'm still loading and shooting them. None of my Starline cases have flaked ...yet.


HWD
Logged

Offline huntducks

  • Trade Count: (4)
  • Contributor
  • ***
  • Posts: 337
  • Gender: Male
Re: Nickel cartridges
« Reply #4 on: October 13, 2009, 09:57:29 AM »
I have flat wore out N cases splits and just wore off the N have never had one flake off, i'm sure it's not plated right from the get go.
Logged
Remember it's where the first bullet goes out of a cold barrel that counts most.

Offline GH1

  • Trade Count: (1)
  • A Real Regular
  • ****
  • Posts: 939
  • Gender: Male
Re: Nickel cartridges
« Reply #5 on: October 13, 2009, 11:38:38 AM »
You know, I never thought of that.  If the case was dirty or oily before it was plated that would certainly cause a problem.  Hopefully it's an isolated incident, thanks for all the answers guys.
GH1 :)
Logged
I owe my life to an organ donor
Pages: [1]   Go Up
« previous next »