« previous next »
Pages: [1]   Go Down

Author Topic: Anyone want to guess at the shim size  (Read 407 times)

0 Members and 2 Guests are viewing this topic.

Offline peternap

  • Trade Count: (5)
  • Contributor
  • ***
  • Posts: 385
Anyone want to guess at the shim size
« on: October 21, 2009, 09:10:37 AM »
I'm fitting the 45/70 barrel to last nights receiver.
Headspace and everything else is perfect ...except the shelf. The latch is all the way up. No rattle but I have to raise the shelf some.

The more I look at it, the more it looks like there i no way to measure for the shim. I'm guesing at about .009 but that' just a guess. Anyone who's done one want to give it a try.
Logged

Offline quickdtoo

  • Global Moderator
  • Trade Count: (149)
  • Senior Member
  • *****
  • Posts: 43301
  • Gender: Male
Re: Anyone want to guess at the shim size
« Reply #1 on: October 21, 2009, 09:14:35 AM »
Install a temp shim and try it, you can always work it down if it's too thick, I believe that's how Partsman did his in the FAQs.  ;)

Tim
Logged
"Always do right, this will gratify some and astonish the rest" -  Mark Twain

Offline petemi

  • GBO Supporter
  • Trade Count: (73)
  • Senior Member
  • *****
  • Posts: 7386
  • Gender: Male
Re: Anyone want to guess at the shim size
« Reply #2 on: October 21, 2009, 01:08:13 PM »
Hey AtlLaw, Richard!!  This guy needs a shim.  I'll get right down there and work on it. ;)  You wanna do glass or aluminum ::)

Pete
Logged
Keep both eyes open and make the first shot good.
The growing Handi/Sportster/Pardner/Topper Family:  .22 WMR, .22-250. 223, Two Superlight 7mm-08s and one .243, .30-30,  .308, 32-20, 18 inch .356/.358 Win., Two 16.5 inch .357 Max., 18 inch 38-55 BC Carbine, 16.5 inch .445 Super Mag., .45LC, 16.5 and 22 inch .45-70s, .50 Huntsman SS, .410, 20 ga., 12 ga., 20 ga. Pardner Pump, Versa-Pack .410 - .22
[size=7.4 pt]PLEASE DONATE TO THE GBO SERVER FUND  We're closer to the goal but not there yet, we can still use more donations, thanks

http://www.gboreloaded.com/forums/index.php/topic,191112.msg1098959491.html#msg1098959491

Offline peternap

  • Trade Count: (5)
  • Contributor
  • ***
  • Posts: 385
Re: Anyone want to guess at the shim size
« Reply #3 on: October 21, 2009, 01:10:51 PM »
Quote from: petemi on October 21, 2009, 01:08:13 PM
Hey AtlLaw, Richard!!  This guy needs a shim.  I'll get right down there and work on it. ;)  You wanna do glass or aluminum ::)

Pete

Turned out it needed .008. I put 010 in and will stone it down tomorrow
Logged
Pages: [1]   Go Up
« previous next »