Brass Bore Protector

[1Longbow]

Where would I find a brass (or other materials) bore protector for cleaning  a side lock as to not to ruin the front of the barrel--Thanks 1Longbow

[necchi]

track, dixie,

http://www.trackofthewolf.com/(S(gtldz0urjs24uo55mkthupuy))/Categories/tableList.aspx?catId=6&subId=49&styleId=159

or a local gun range, old fired brass cartidges work.

[Victor3]

 For disposable ones, plastic straws or paper tubes of appropriate diameter work. A few wraps of tape around the end keeps them from sliding into the bore.

[Winter Hawk]

I use a flare nut I picked up at the hardware store years ago.  I think it is a 3/8", I may have drilled it out a tad to accomodate the ramrod.  As I say, I have had this in my shooting bag for many years.  Actually seldom use it, though.

-Kees-

[Les Staley]

Get a 45-70 empty brass, drill out the primer pocket end for your rammer, the rim will keep it from going down a 50 cal.  Cheap and works good..  Les

[1Longbow]

Thanks for all the replies and ideas--1Longbow