« previous next »
Pages: [1]   Go Down

Author Topic: can't get the grip frame screws back in on single-six  (Read 450 times)

0 Members and 1 Guest are viewing this topic.

Offline tcjason

  • Trade Count: (9)
  • Member
  • *
  • Posts: 30
can't get the grip frame screws back in on single-six
« on: November 21, 2009, 06:20:05 PM »
I have a three screw, round load gate SS.  It was binding up so i took it apart and cleaned it.  now I can't get the two screws on the rear top of the grip frameto start back in. Just will not start in the holes.  Anybody know what the trick is?  thanks
Logged

Offline gunblade

  • Trade Count: (0)
  • Member
  • *
  • Posts: 78
Re: can't get the grip frame screws back in on single-six
« Reply #1 on: November 23, 2009, 02:36:53 PM »
If you've already tightened the other screws up, maybe the frame isn't exactly lined up and the remaining two screw holes are slightly askew.  Might try leaving all the screws loose until they are all in then tighten 'em up a little at a time.
Logged

Offline flatgate

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 158
Re: can't get the grip frame screws back in on single-six
« Reply #2 on: December 25, 2009, 03:21:25 AM »
I hate to ask this but do you have the mainspring "captured"?

And the posted advice to get all five screws started before tightening any of them is very important.

JMHO,

flatgate
Logged
Pages: [1]   Go Up
« previous next »