« previous next »
Pages: [1]   Go Down

Author Topic: Thinner recoil pad for stainless lite  (Read 639 times)

0 Members and 1 Guest are viewing this topic.

Offline kenscot

  • Trade Count: (0)
  • Contributor
  • ***
  • Posts: 372
Thinner recoil pad for stainless lite
« on: November 24, 2009, 02:59:17 AM »
I really like my new T-3. I would just like a thinner recoil pad to shorten the LOP It fits fine in light jackets but I find it a little long while where heavier gear. Since its in 308 win I am not to worried about additional recoil  Thanks
Logged

Offline Harry Snippe

  • Trade Count: (0)
  • A Real Regular
  • ****
  • Posts: 641
  • Gender: Male
Re: Thinner recoil pad for stainless lite
« Reply #1 on: November 24, 2009, 11:22:34 AM »
Guess that leaves you looking for a thin grind to fit 1/4" pad they used on some rifles of the fiftys / sixties . Then too you might find a  solid piece to fit your gun.
Logged
Happy

Offline longwinters

  • Moderators
  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 3070
Re: Thinner recoil pad for stainless lite
« Reply #2 on: November 25, 2009, 03:26:15 PM »
Is the problem with reaching the trigger or eye relief?

Long
Logged
Life is short......eternity is long.

Offline kenscot

  • Trade Count: (0)
  • Contributor
  • ***
  • Posts: 372
Re: Thinner recoil pad for stainless lite
« Reply #3 on: November 28, 2009, 01:57:42 PM »
It's not a real problem as I managed to drop two deer with it last week. I have just grown like the shorter LOP of my browning micro hunters and was looking to duplicate it.
Logged
Pages: [1]   Go Up
« previous next »