Author Topic: moss 500A or 500  (Read 341 times)

0 Members and 2 Guests are viewing this topic.

Offline fuzzy

  • Trade Count: (7)
  • Avid Poster
  • **
  • Posts: 245
  • Gender: Male
moss 500A or 500
« on: November 26, 2009, 04:00:03 PM »
My friend has a 500A 12ga the barrels don`t fit tight you can twist them left to right just a tad when seated dont seam to lock in the reciver nochies quite right  Any help thanks
Rich
 
  Logged 
 
I rather be over the hill than in it

Offline gunnut69

  • Moderators
  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 5005
Re: moss 500A or 500
« Reply #1 on: November 27, 2009, 07:27:14 AM »
I can find no distiction between the 500 and 500A. The Mossberg 500 series shotgun uses an aluminum receiver which takes little stress from firing but is fairly soft. Wear can become an issue with repeated takedown or even with extended use. I've seen some that allowed the bolt carrier to move under the stress of firing and the bolt would unlock in a violent manner. Not quite a 'blow open' but close. If the gun cycles OK then some looseness is normal if there is a question then a gunsmith should get involved or even a return trip to Mossberg. Also a call the O.F.Mossberg customer service is in order. I've posted a link to their website below.. Good luck and let us know how it works out.. I've had good luck with their customer service

people..http://www.mossberg.com/content.asp?ID=522&section=service
gunnut69--
The 2nd amendment to the constitution of the United States of America-
"A well regulated militia, being necessary to the security of a free state, the right of the people to keep and bear arms, shall not be infringed."

Offline fuzzy

  • Trade Count: (7)
  • Avid Poster
  • **
  • Posts: 245
  • Gender: Male
Re: moss 500A or 500
« Reply #2 on: November 28, 2009, 05:06:05 AM »
Thanks gunnut ill give them a call monday and see what they say
I rather be over the hill than in it