« previous next »
Pages: [1]   Go Down

Author Topic: Refinishing question  (Read 457 times)

0 Members and 2 Guests are viewing this topic.

Offline kbush

  • Trade Count: (17)
  • Member
  • *
  • Posts: 98
Refinishing question
« on: December 15, 2009, 03:25:50 PM »
Have a marlin 1894 in .357 that has been plated, most likely nickel but possibly hard chromed.  Is it possible to have this removed and another finsih applied?  Would it be best to just have it camo dipped or another baked on finish applied?

I also need to have the carrier fixed to cure the "jam" so I'm thinking this was a CAS gun at one time.
Logged

Offline gunnut69

  • Moderators
  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 5005
Re: Refinishing question
« Reply #1 on: December 16, 2009, 05:40:42 AM »
As to the 'jam' that could well be caused by a lot of use.. It is basically damage to the stopping edge of the lifter caused by wear, impact and a bit of poor design.. Plating can usually be removed but the substrates may not be pretty.. Of course if replating it should not create too much of a problem. I don't know what you're looking for so can't speak to what's best but black chrome is neat and one of the Armaloy type hard chrome finishes can add a lot of rust resistance to a carry rifle.. If it's simply too shiney a simple Black-T or other baked on finish should work and will solve the light color problem with the least outlay of cash.. Of course if its just the color powder coating the exterior can be used to solve the problem very ecconomically.
Logged
gunnut69--
The 2nd amendment to the constitution of the United States of America-
"A well regulated militia, being necessary to the security of a free state, the right of the people to keep and bear arms, shall not be infringed."

Offline Swampman

  • GBO Supporter
  • Trade Count: (44)
  • Senior Member
  • *****
  • Posts: 16518
  • Gender: Male
Re: Refinishing question
« Reply #2 on: December 16, 2009, 06:27:25 AM »
Check the "loading spring (gate) screw" it may be loose.  Do not over tighten.  It breaks pretty easy.  These guns normally need a bullet profile that feeds easy or they will jam.
Logged
"Brother, you say there is but one way to worship and serve the Great Spirit. If there is but one religion, why do you white people differ so much about it? Why not all agreed, as you can all read the Book?" Sogoyewapha, "Red Jacket" - Senaca

1st Special Operations Wing 1975-1983
919th Special Operations Wing  1983-1985 1993-1994

"Manus haec inimica tyrannis / Ense petit placidam sub libertate quietem" ~Algernon Sidney~

Offline kbush

  • Trade Count: (17)
  • Member
  • *
  • Posts: 98
Re: Refinishing question
« Reply #3 on: December 16, 2009, 09:45:57 AM »
Black T or similar would be fine as far as finish goes.  It don't have to be pretty, just functional.  I'll check the loading gate screw.
Logged
Pages: [1]   Go Up
« previous next »