« previous next »
Pages: [1]   Go Down

Author Topic: 8" 44 mag Bull barrel?  (Read 453 times)

0 Members and 1 Guest are viewing this topic.

Offline alan in ga

  • Trade Count: (13)
  • A Real Regular
  • ****
  • Posts: 692
8" 44 mag Bull barrel?
« on: October 28, 2003, 01:42:58 AM »
anyone have and used an 8" barrel? Just wondering how different it is to shoot compared to a full 10". I would be deer hunting with one,,,and wonder about the muzzle blast difference. I DON'T use revolvers anymore because of the serious blast the cylinder gap can give. If resting pistol next to tree trunk [common in tree stands], the 'side blast' is bounced right back at shooter with some bark mixed in to boot.
Still thinking of best use for the 10" bull barrel I just got with an internal choke. No rib,,just standard open sight bull barrel in 44 Mag.
thanks, I appreciate the responses and opinions offered here.
alan in ga.
Logged

Offline rickyp

  • Trade Count: (19)
  • Senior Member
  • *****
  • Posts: 3052
  • Gender: Male
8" 44 mag Bull barrel?
« Reply #1 on: October 28, 2003, 02:37:35 AM »
well you could aleays cut it back to 8 inches then have it rechambered to a 445 s.m.  but the bark will be quite loud.
I beleave the hotshot chamber is cut a litle longer then a normal one. that i why I was thinking about rechambering it .
Logged

Offline Questor

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 7075
8" 44 mag Bull barrel?
« Reply #2 on: October 28, 2003, 02:59:45 AM »
You may have swapped a little blast for a lot of recoil. I hated my 44 10" until I put pachmayr grip and foreend on it.  Shortening the barrel won't help.  Blast is very much a function of the powder and the load. I find that loads based on 296 and most any 240 grain or 300 grain bullet has blast that's not objectionable.
Logged
Safety first

Offline Pinkerton

  • Trade Count: (5)
  • Contributor
  • ***
  • Posts: 259
8" 44 mag Bull barrel?
« Reply #3 on: October 28, 2003, 06:04:27 AM »
I have an 8" 44mag with integral MB machined in, it has 14" screw spacing for the forend and has a trimmed herrett forend that makes the whole package look really great, works great with a red dot site.  I really like the weight and feel of it better than my 10" and If you hotshot barrel is accurate I wouldn't hesitate to loob of a couple inches.

good luck
Logged

Offline KYODE

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 1050
  • Gender: Male
8" 44 mag Bull barrel?
« Reply #4 on: October 28, 2003, 07:12:04 AM »
don't know much about the subject, but the barrel may be a good candidate to stub in front of the chamber, and add a threaded longer tube to it. i've seen them around on the net, but thats about all i know. :?
Logged
Pages: [1]   Go Up
« previous next »