« previous next »
Pages: [1]   Go Down

Author Topic: 92 feed problems  (Read 794 times)

0 Members and 1 Guest are viewing this topic.

Offline teamnelson

  • Trade Count: (30)
  • Senior Member
  • *****
  • Posts: 4487
  • Gender: Male
92 feed problems
« on: January 23, 2010, 02:56:25 PM »
Took the 92 carbines out today with some pmc 158gr jsp. The new emf loaded great, but my older rossi wouldn't feed. The feed angle was too steep but if I backed it off it would pop level then slide in when finished the lever.

Any thoughts? Do I have a weak feed spring? :scratching head:
Logged
held fast

Offline yukondog

  • GBO Supporter
  • Trade Count: (43)
  • Senior Member
  • *****
  • Posts: 1095
Re: 92 feed problems
« Reply #1 on: January 26, 2010, 04:26:26 AM »
Is it a 38 or 357 and does it do it with other ammo? It might be that the OAL of that cart. is to long, I know in my 454 m-92 it's real picky about OAL and wont chamber a round that is to long.
Logged
an unloaded wepon is equal to the same mass and volume as a rock.

Offline Dee

  • Trade Count: (2)
  • Senior Member
  • *****
  • Posts: 23870
  • Gender: Male
Re: 92 feed problems
« Reply #2 on: January 26, 2010, 07:21:23 AM »
TN, I have a Rossi imported by Navy Arms. Slick little rifle with walnut stocks. I had to cut a new ejector, and while I had it apart I re cut the extractor HOWEVER! It doesn't feed semi wad cutters well, but is as slick as snot on a door knob with the round you posted IN 357 mag. It CAN occasionally hang a little with the same bullet on 38 special, but rarely.
Are you snappin the action all the way open or could you be short strokin it?
Logged
You may all go to hell, I will go to Texas. Davy Crockett
Pages: [1]   Go Up
« previous next »