Author Topic: Bullet jump to rifleings  (Read 314 times)

0 Members and 1 Guest are viewing this topic.

Offline Catfish

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 2696
Bullet jump to rifleings
« on: March 28, 2010, 10:06:57 AM »
Yesterday I got out a .17 MK lV that I traded for in Dec. I worked up a powder charge with the bullets jammed into the rifleings. That way I would not have to worry about high presure as I worked with bullet setting depth. Jammed hard into the rifleings I fired 3 shot groups with 20 gr. Hornday`s, 20 gr, Bergers and 22 gr. Calhoons. The C`s were the best with a .545. H`s were .792 and B`s were 1,425. Backed out .010 the C`s were .250, the H`s .712 and the B`s .935. Backed out another .020 the B`s had dropped to .225 with the H`s at .528 and I pulled a shot with the C`s and they went up to .579 with 2 bullets touching. I could not seat the bullets any deeper with the Redding dies I have so no farther test. This gun like a long jump more than any gun I have worked with for a long time, maybe ever. It proved to me, again, that you should always play with the seating depth when going for your best accuracy. I have had guns where it didn`t matter much and others that it was flat critical. With the best shooters it seems to matter more, most of the time.

Offline stimpylu32

  • Moderators
  • Trade Count: (67)
  • Senior Member
  • *****
  • Posts: 6062
  • Gender: Male
Re: Bullet jump to rifleings
« Reply #1 on: March 28, 2010, 12:33:45 PM »
Catfish

I too have found that in most cases , bullet seating depth has more of an effect on group size than powder charge . With my last rifle , a 223 Rem -Stevens 200 , going +/- .015 in seating depth made more of a difference than +/- 1 full grain of powder using both BLC-2 as well as Varget .

Yet I have other rifles that did not care were the bullet was seated .

stimpy 
Deceased June 17, 2015


:D If i can,t stop it with 6 it can,t be stopped