« previous next »
Pages: [1]   Go Down

Author Topic: Non-d&t rifle sights?  (Read 1100 times)

0 Members and 1 Guest are viewing this topic.

Offline TheCoachZed

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 120
  • Gender: Male
  • Who wants some?
Non-d&t rifle sights?
« on: May 03, 2010, 02:28:20 PM »
Is there any way I can put rifle-style sights on my H&R Survivor 12 gauge without drilling and tapping the barrel?
Logged
My avatar is pretty much what I look like out in the woods - except I am not a "chick" in any sense of the word.

Offline STUMPJMPR

  • Trade Count: (4)
  • Senior Member
  • *****
  • Posts: 1037
Re: Non-drilled and tapped rifle sights?
« Reply #1 on: May 04, 2010, 04:09:06 PM »
You can use loctite black max or other epoxy
Logged

Offline bubba.50

  • GBO Supporter
  • Trade Count: (151)
  • Senior Member
  • *****
  • Posts: 1170
  • Gender: Male
Re: Non-drilled and tapped rifle sights?
« Reply #2 on: May 04, 2010, 04:28:57 PM »
j-b weld. it's slow drying and kinda messy but it works good for me. another good one i use is advance auto's version of j-b quick 5 minute epoxy. gives a little more work time, is stronger and more forgiving than j-b quick. of course i usually scuff up where the sight is going with sandpaper. good luck and happy shootin', bubba.
Logged
fetch the hammer maggie-they's a bee on the baby's head!

Offline TheCoachZed

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 120
  • Gender: Male
  • Who wants some?
Re: Non-drilled and tapped rifle sights?
« Reply #3 on: May 04, 2010, 04:40:32 PM »
Hrm. Well I guess I will see . .. I could put firesights on my Winchester 1300 a lot easier and have 5 shells to boot ... too bad it's not as easy to handle in the woods.  :-\
Logged
My avatar is pretty much what I look like out in the woods - except I am not a "chick" in any sense of the word.

Offline tony212

  • Trade Count: (3)
  • Contributor
  • ***
  • Posts: 280
Re: Non-drilled and tapped rifle sights?
« Reply #4 on: May 05, 2010, 01:48:58 AM »
What sights did you use?  I was thinking about adding sights to my 088 but didn't know which ones to get.
Tony212
Logged

Offline STUMPJMPR

  • Trade Count: (4)
  • Senior Member
  • *****
  • Posts: 1037
Re: Non-drilled and tapped rifle sights?
« Reply #5 on: May 05, 2010, 03:07:31 AM »
You will need a williams shorty front ramp.  I used a william's peep sight for the rear.
Logged
Pages: [1]   Go Up
« previous next »