« previous next »
Pages: [1]   Go Down

Author Topic: Extraction problem: Federal .410 buckshot load  (Read 607 times)

0 Members and 1 Guest are viewing this topic.

Offline BillinOregon

  • GBO Supporter
  • Trade Count: (4)
  • Avid Poster
  • *****
  • Posts: 222
Extraction problem: Federal .410 buckshot load
« on: July 20, 2010, 05:56:41 AM »
For some reason this particular load (2 1/2-inch 000 buck) will not extract without cleaning rod assistance in my .410 Tamer. Anyone else notice this?
Logged

Offline quickdtoo

  • Global Moderator
  • Trade Count: (149)
  • Senior Member
  • *****
  • Posts: 43301
  • Gender: Male
Re: Extraction problem: Federal .410 buckshot load
« Reply #1 on: July 20, 2010, 05:58:29 AM »
Follow the advice in the FAQs and Help sticky on chamber polishing and do the ejector tune, also in the FAQs.  ;)

Tim
Logged
"Always do right, this will gratify some and astonish the rest" -  Mark Twain

Offline Kal52

  • Trade Count: (16)
  • Contributor
  • ***
  • Posts: 380
Re: Extraction problem: Federal .410 buckshot load
« Reply #2 on: July 22, 2010, 01:32:19 PM »
I did the chamber polish, I may need to tune.
Mine hates federal hulls, buckshot more than the others  :D

Good luck with yours

Dave
Logged

Offline shaner

  • GBO Supporter
  • Trade Count: (66)
  • Senior Member
  • *****
  • Posts: 2057
  • Gender: Male
Re: Extraction problem: Federal .410 buckshot load
« Reply #3 on: July 24, 2010, 05:06:32 AM »
federal hulls  in 410  suck man ive shot 410's for years  and even in different guns  then NEF  they stick , i guess they are a softer  brass? not sure,  and they are of no use to reload either hahaha
Logged
Pages: [1]   Go Up
« previous next »