« previous next »
Pages: [1]   Go Down

Author Topic: 10 ga barrel diameter  (Read 490 times)

0 Members and 1 Guest are viewing this topic.

Offline 10gaugeMS^_^

  • Trade Count: (0)
  • Member
  • *
  • Posts: 85
10 ga barrel diameter
« on: August 04, 2010, 01:16:24 PM »
I asked about the scnable foreamr for 10 gauge etc. well i traded a 20 ga semi auto for a h&r 10 ga. the barrel channel in the forearm is 1 1/8 " the barrel diameter itself is only a fraction smaller . can any one measure the width of their scnable foreend
Logged
In theory its sound ",but in practice its flawed

Offline quickdtoo

  • Global Moderator
  • Trade Count: (149)
  • Senior Member
  • *****
  • Posts: 43301
  • Gender: Male
Re: 10 ga barrel diameter
« Reply #1 on: August 04, 2010, 04:26:56 PM »
I measured 3 of them, 1.42" is the narrowest, 1.47" the widest, but it's only .715" thick at the shallow part just behind the bulb at the tip, not much depth to work with there.

Tim
Logged
"Always do right, this will gratify some and astonish the rest" -  Mark Twain

Offline 10gaugeMS^_^

  • Trade Count: (0)
  • Member
  • *
  • Posts: 85
Re: 10 ga barrel diameter
« Reply #2 on: August 05, 2010, 06:42:44 AM »
ever seen the super thin slpenter forearms on old sxs's thats alm ost paper thin around the barrels ? I imagine it would be somthing like that but longs as i never took it off or beat it against somthing it might work . or get one made from thicker blank of wood
Logged
In theory its sound ",but in practice its flawed

Offline 10gaugeMS^_^

  • Trade Count: (0)
  • Member
  • *
  • Posts: 85
Re: 10 ga barrel diameter
« Reply #3 on: August 05, 2010, 06:46:33 AM »
the forend is 1.47 the channel has to be 1.125 you would have .345" materail left
Logged
In theory its sound ",but in practice its flawed

Offline quickdtoo

  • Global Moderator
  • Trade Count: (149)
  • Senior Member
  • *****
  • Posts: 43301
  • Gender: Male
Re: 10 ga barrel diameter
« Reply #4 on: August 05, 2010, 06:50:22 AM »
That's .1725" on each side and likely a hole in the bottom at the thin part!!  :-\

Tim
Logged
"Always do right, this will gratify some and astonish the rest" -  Mark Twain
Pages: [1]   Go Up
« previous next »