« previous next »
Pages: [1]   Go Down

Author Topic: Shot Shell Crimp  (Read 865 times)

0 Members and 1 Guest are viewing this topic.

Offline Robert lehman

  • Trade Count: (0)
  • Member
  • *
  • Posts: 60
  • Gender: Male
Shot Shell Crimp
« on: August 11, 2010, 04:28:47 PM »
What do you guys use to open up the crimp on shot shells. The reason i ask buddy of mine gave roughly 50 rnds of shot shells that were in a flood primers starting to corrode. Thought i would open them up and dump the shot and throw the rest away.
Logged

Offline rickyp

  • Moderator
  • Trade Count: (19)
  • Senior Member
  • *****
  • Posts: 3052
  • Gender: Male
Re: Shot Shell Crimp
« Reply #1 on: August 11, 2010, 04:32:53 PM »
if I do not want to save the hull, I personaly use a droumal tool with a cut off wheel and cut off the top of the shell right below the crimp.

If the primers and all are rusting they shot may not be the best .
Logged

Offline Robert lehman

  • Trade Count: (0)
  • Member
  • *
  • Posts: 60
  • Gender: Male
Re: Shot Shell Crimp
« Reply #2 on: August 11, 2010, 04:55:52 PM »
Thanks Rickyp don't own a dremmel tool thought about using a utility knife but was hopping some one had a faster idea. As for the condition of the lead if its corroded i will smelt it and use for casting bullets.
Logged

Offline rickyp

  • Moderator
  • Trade Count: (19)
  • Senior Member
  • *****
  • Posts: 3052
  • Gender: Male
Re: Shot Shell Crimp
« Reply #3 on: August 11, 2010, 04:59:51 PM »
Led shot is not the best for casting bullets it has a high leveal of arsnic and will not let the bullets fill out well.

Be careful with teh knife as the hulls are tough to cut.
Logged
Pages: [1]   Go Up
« previous next »