« previous next »
Pages: [1]   Go Down

Author Topic: Browning 22 copy (Norinco ATD) stock removal  (Read 1242 times)

0 Members and 1 Guest are viewing this topic.

Offline new22shooter

  • Trade Count: (0)
  • Posts: 1
Browning 22 copy (Norinco ATD) stock removal
« on: August 17, 2010, 07:50:23 PM »
hello, I have a Norinco ATD fires great but the stock feels loose. the stock wiggles kind of freely from the receiver assembly. I do not know how to tighten it there are no screws leading to it so i figured there is a loose screw in the assembly attached to it, but i do not know how to remove it. any information on how to tighten the stock would be appreciated, thanks.
Logged

Offline Lurker

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 205
Re: Browning 22 copy (Norinco ATD) stock removal
« Reply #1 on: August 17, 2010, 07:58:23 PM »
Quote from: new22shooter on August 17, 2010, 07:50:23 PM
hello, I have a Norinco ATD fires great but the stock feels loose. the stock wiggles kind of freely from the receiver assembly. I do not know how to tighten it there are no screws leading to it so i figured there is a loose screw in the assembly attached to it, but i do not know how to remove it. any information on how to tighten the stock would be appreciated, thanks.

Remove the magazine tube, remove the screws from the butt pad and you should find the bolt that holds the stock to the receiver. That is if it is like a real browning...

Bill
Logged
Pages: [1]   Go Up
« previous next »