« previous next »
Pages: [1]   Go Down

Author Topic: ROA .45 Colt loads  (Read 837 times)

0 Members and 1 Guest are viewing this topic.

Offline Range Rider

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 228
  • Gender: Male
  • Have a nice day cowboy
ROA .45 Colt loads
« on: September 02, 2010, 08:42:43 PM »
What bullet are using in the ROA Taylor or R&D Conv. cylinder?  In order to load for the Conv. the heavy slugs have to be pushed too far into the case.  Some of the little 200 grs. wad cutters will work but these bullets are to light for my use. What molds are you using?


Logged
Range Rider

Offline beerbelly

  • Trade Count: (6)
  • Senior Member
  • *****
  • Posts: 1625
Re: ROA .45 Colt loads
« Reply #1 on: September 03, 2010, 04:27:16 AM »
I have the ROA and the R&D . I am using the Lee, .452 diameter, 255 grain mold.
 # 452-255-RF
                                     Beerbelly
Logged

Offline Range Rider

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 228
  • Gender: Male
  • Have a nice day cowboy
Re: ROA .45 Colt loads
« Reply #2 on: September 04, 2010, 05:26:32 AM »
Thx BB I will check that one out.  What powder are you using?  I have tried the Trail Boss but not impressed.
Logged
Range Rider

Offline beerbelly

  • Trade Count: (6)
  • Senior Member
  • *****
  • Posts: 1625
Re: ROA .45 Colt loads
« Reply #3 on: September 04, 2010, 07:25:20 AM »
I have been using Unique, and tight groupe.
                     Beerbelly
Logged

Offline Range Rider

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 228
  • Gender: Male
  • Have a nice day cowboy
Re: ROA .45 Colt loads
« Reply #4 on: September 05, 2010, 07:59:46 AM »
Thanks BB.  I found an RCBS .45 mold 255 grs FP in my junk this morning.  Think I will try that one out.
Logged
Range Rider
Pages: [1]   Go Up
« previous next »