« previous next »
Pages: [1]   Go Down

Author Topic: removing barrel from an H&R USHD?  (Read 478 times)

0 Members and 1 Guest are viewing this topic.

Offline 32 Magnum

  • Trade Count: (0)
  • Contributor
  • ***
  • Posts: 269
  • Gender: Male
removing barrel from an H&R USHD?
« on: January 05, 2011, 05:09:12 PM »
Is there a "trick" to removing the forestock and then dismounting the barrel on a USHD? 
Logged
Jim Hauff,  H&R Collector

RIP Jim, passed away on October 12th, 2012

Offline quickdtoo

  • Global Moderator
  • Trade Count: (149)
  • Senior Member
  • *****
  • Posts: 43301
  • Gender: Male
Re: removing barrel from an H&R USHD?
« Reply #1 on: January 05, 2011, 05:14:18 PM »
Remove the forend screw of course, then pull the muzzle end of the forend away from the barrel, sometimes they're on pretty tight, might take some muscle, sometimes it will take a wood block against the forend and a tap or two with a hammer. Then remove the spacer and flat sand the spacer so the forend doesn't fit so tight when you reinstall the forend!   ;D

Tim
Logged
"Always do right, this will gratify some and astonish the rest" -  Mark Twain

Offline 32 Magnum

  • Trade Count: (0)
  • Contributor
  • ***
  • Posts: 269
  • Gender: Male
Re: removing barrel from an H&R USHD?
« Reply #2 on: January 05, 2011, 05:24:29 PM »
Tim,
Thanks, amigo.  I'll pass this along to my "friend" out in the netherworld.  This is basically what I told him and he told me he can't get the fore stock to move.
Jim
Logged
Jim Hauff,  H&R Collector

RIP Jim, passed away on October 12th, 2012
Pages: [1]   Go Up
« previous next »