« previous next »
Pages: [1]   Go Down

Author Topic: Drill and tap for scope ?  (Read 466 times)

0 Members and 1 Guest are viewing this topic.

Offline Redhawk1

  • Life time NRA Supporter.
  • GBO Supporter
  • Trade Count: (78)
  • Senior Member
  • *****
  • Posts: 10748
  • Gender: Male
Drill and tap for scope ?
« on: December 18, 2003, 01:34:02 AM »
Off hand I forgot the size of the standard threads size for mounts for a scope. Is it 6-32 or 6-40?
Thanks in advance.
Logged
If  you're going to make a hole, make it a big one.
ΜΟΛΩΝ ΛΑΒΕ
Only two defining forces have ever offered to die for you,
Jesus Christ and the American G. I.
One died for your soul, the other for your freedom

Endowment Life Member of the NRA
Life Member NA

Offline John Traveler

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 1359
thread size
« Reply #1 on: December 18, 2003, 11:08:09 AM »
The US standard guns screws are 6-48 and 8-48.
Logged
John Traveler

Offline KN

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 1962
Drill and tap for scope ?
« Reply #2 on: December 18, 2003, 11:57:47 AM »
I have used 6-40 screws plenty of times with no problems. Just use good lock tite.  KN
Logged

Offline Iowegan

  • Trade Count: (0)
  • A Real Regular
  • ****
  • Posts: 646
Drill and tap for scope ?
« Reply #3 on: December 20, 2003, 05:20:46 PM »
You're bouncing around the right ones... 6X48 and 8X40 are the standard sight / scope threads.
Logged
GLB

Offline Bug

  • Trade Count: (2)
  • Contributor
  • ***
  • Posts: 322
I Agree,
« Reply #4 on: December 21, 2003, 03:43:10 PM »
With Iowegan :)
 Most STANDARD holes are 6x48. The ones with some forethought, or that have been redone are 8x40. But, there are still some oddballs floating around out there, not to mention the METRIC sizes! (shudder!)....Bug.
Logged
It's The Little Things That Matter.
Pages: [1]   Go Up
« previous next »