Author Topic: Flat top 44 speclal  (Read 1004 times)

0 Members and 1 Guest are viewing this topic.

Offline Northern Flatlander

  • Trade Count: (0)
  • Member
  • *
  • Posts: 23
  • Gender: Male
Flat top 44 speclal
« on: March 20, 2011, 03:21:14 PM »
Hia Folks
As I cannot gather from the ruger site anything describing the grip-frame, I thought to ask here.
Is the grip frame on the NVB-444/445-spcl (smaller framed flat-top) patterned close to the XR-3, or does it have the usual XR-3 RED size?
Thanks aplenty

Offline coyotejoe

  • Trade Count: (4)
  • Senior Member
  • *****
  • Posts: 2937
  • Gender: Male
Re: Flat top 44 speclal
« Reply #1 on: March 21, 2011, 03:42:52 AM »
The flat top and the New Vaquero use a grip frame "closer" to the old XR-3 grip but there does seem to be a lot of variation among individual guns as to exact grip fit and the Ruger black plastic grips don't seem to exactly fit anything.
The story of David & Goliath only demonstrates the superiority of ballistic projectiles over hand weapons, poor old Goliath never had a chance.

Offline texagun

  • Trade Count: (0)
  • Member
  • *
  • Posts: 98
Re: Flat top 44 speclal
« Reply #2 on: March 29, 2011, 08:03:27 AM »


Everything you need to know about Ruger Grip Frames:

http://www.gunblast.com/Hamm_Ruger-SA-GripFrames.htm

Offline coyotejoe

  • Trade Count: (4)
  • Senior Member
  • *****
  • Posts: 2937
  • Gender: Male
Re: Flat top 44 speclal
« Reply #3 on: March 30, 2011, 05:23:51 AM »
Thanks for the link, that's very useful. The only other thing folks need to know is that the grip frame is assembled to the cylinder frame and the two pieces are then finished as a unit. For that reason swapping grip frames from one cylinder frame to another will likely result in neither fitting quite perfectly.
The story of David & Goliath only demonstrates the superiority of ballistic projectiles over hand weapons, poor old Goliath never had a chance.