« previous next »
Pages: [1]   Go Down

Author Topic: HS-5 and HS-7 Load data needed.  (Read 780 times)

0 Members and 1 Guest are viewing this topic.

Offline mtbugle

  • Trade Count: (32)
  • Contributor
  • ***
  • Posts: 355
  • Gender: Male
HS-5 and HS-7 Load data needed.
« on: May 16, 2011, 07:23:36 PM »
I have some old powder that is in good shape and would like to utilize it.  It is the two listed above and I can not find any load data to these obsolete powders.  I have 22 jet, 38 special,357 mag, 357 max, 44 mag. that I think may fall in this powder range. Thanks IN advance.
Thanks Don.
Logged

Offline stimpylu32

  • Moderators
  • Trade Count: (67)
  • Senior Member
  • *****
  • Posts: 6062
  • Gender: Male
Re: HS-5 and HS-7 Load data needed.
« Reply #1 on: May 17, 2011, 12:07:49 PM »
Don

Lee's 2nd Ed. lists quite a bit of data for the 44 mag using HS-7 and Steves pages have data for the 357 mag with the same powder , I have not been able to find anything for the HS-5 even going back to my old Lyman 45th. Ed. from 1970 .

stimpy
Logged
Deceased June 17, 2015


:D If i can,t stop it with 6 it can,t be stopped

Offline mtbugle

  • Trade Count: (32)
  • Contributor
  • ***
  • Posts: 355
  • Gender: Male
Re: HS-5 and HS-7 Load data needed.
« Reply #2 on: May 17, 2011, 04:35:27 PM »
Thanks a lot stimpy. If possible maybe you could pm some of those loads if not comfortable with putting on everyones view. I have 200 and 225 grain 44's, and 158 in the 357.
Thanks Don.
Logged

Offline huntducks

  • Trade Count: (4)
  • Contributor
  • ***
  • Posts: 337
  • Gender: Male
Re: HS-5 and HS-7 Load data needed.
« Reply #3 on: May 18, 2011, 12:02:22 PM »
I also sent you a PM
Logged
Remember it's where the first bullet goes out of a cold barrel that counts most.

Offline mtbugle

  • Trade Count: (32)
  • Contributor
  • ***
  • Posts: 355
  • Gender: Male
Re: HS-5 and HS-7 Load data needed.
« Reply #4 on: May 19, 2011, 07:16:52 AM »
Thanks a lot guys for the loads. I have a good idea where to start with HS-7 now. Does any one else have much for HS-5?
Thanks Don.
Logged

Offline huntducks

  • Trade Count: (4)
  • Contributor
  • ***
  • Posts: 337
  • Gender: Male
Re: HS-5 and HS-7 Load data needed.
« Reply #5 on: May 19, 2011, 05:38:15 PM »
Just too add HS-5 has a burn rate about same as Accurate Solo 1250 IMR-PB and Universal clays.
Logged
Remember it's where the first bullet goes out of a cold barrel that counts most.
Pages: [1]   Go Up
« previous next »