« previous next »
Pages: [1]   Go Down

Author Topic: Remington 522 Viper barrel  (Read 635 times)

0 Members and 1 Guest are viewing this topic.

Offline watsisname

  • Trade Count: (56)
  • Contributor
  • ***
  • Posts: 353
Remington 522 Viper barrel
« on: May 20, 2011, 05:45:13 AM »
I want to refinish the barrel on my .22 Viper. I have had this rifle completely stripped down several times but have never removed the barrel. Can anyone tell me how to remove the barrel from the receiver? Thanks.
Logged

Offline gunnut69

  • Moderators
  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 5005
Re: Remington 522 Viper barrel
« Reply #1 on: May 20, 2011, 02:05:51 PM »
Below is a link to a parts diagram but it refers to the 'receiver/barrel group' with no indication of how these are married. usually they are pressed into place and sometimes retained but a pin. I see no evidence for such going on here.. Does the refinish rally require the barrel be removed? Some rimfires are screwed into place but I doubt this is the case here. Perhaps it would be best to finish the assembly as a unit..?


http://stevespages.com/ipb-remington-522.html
Logged
gunnut69--
The 2nd amendment to the constitution of the United States of America-
"A well regulated militia, being necessary to the security of a free state, the right of the people to keep and bear arms, shall not be infringed."
Pages: [1]   Go Up
« previous next »