« previous next »
Pages: [1]   Go Down

Author Topic: The making of foil cannon cartridges... Your comments are appreciated...  (Read 792 times)

0 Members and 3 Guests are viewing this topic.

Offline flagman1776

  • GBO Supporter
  • Trade Count: (3)
  • A Real Regular
  • *****
  • Posts: 795
  • Gender: Male
The making of foil cannon cartridges... Your comments are appreciated...
« on: July 06, 2011, 02:46:16 PM »
delete
Logged

Offline flagman1776

  • GBO Supporter
  • Trade Count: (3)
  • A Real Regular
  • *****
  • Posts: 795
  • Gender: Male
Re: The making of foil cannon cartridges... Your comments are appreciated...
« Reply #1 on: July 06, 2011, 02:53:30 PM »
delete
Logged

Offline GGaskill

  • Moderator
  • Trade Count: (2)
  • Senior Member
  • *****
  • Posts: 5668
  • Gender: Male
Re: The making of foil cannon cartridges... Your comments are appreciated...
« Reply #2 on: July 06, 2011, 02:56:56 PM »
Not exactly the same as I do it but sounds good to me.
Logged
GG
“If you're not a liberal at 20, you have no heart; if you're not a conservative at 40, you have no brain.”--Winston Churchill

Offline moose53

  • GBO Supporter
  • Trade Count: (0)
  • Contributor
  • *****
  • Posts: 430
Re: The making of foil cannon cartridges... Your comments are appreciated...
« Reply #3 on: July 06, 2011, 06:38:37 PM »
A split pipe with a bolt closer would give you dimensional consistency on the O.D.  of the foil cartridge . Once made it is easy to use . You said you had a lathe so it would not be a problem to set up
Logged
Pages: [1]   Go Up
« previous next »