« previous next »
Pages: [1]   Go Down

Author Topic: LimbSaver for thumbhole stock  (Read 311 times)

0 Members and 2 Guests are viewing this topic.

Offline jbrray

  • Trade Count: (2)
  • Member
  • *
  • Posts: 35
LimbSaver for thumbhole stock
« on: July 26, 2011, 06:47:25 PM »
Will the LimbSaver pad #10018 fit thumbhole and laminate stocks? Does anyone use a LimbSaver on their 45-70? Are there better options?

JB 
Logged

Offline quickdtoo

  • Global Moderator
  • Trade Count: (149)
  • Senior Member
  • *****
  • Posts: 43301
  • Gender: Male
Re: LimbSaver for thumbhole stock
« Reply #1 on: July 26, 2011, 06:57:50 PM »
The 10018 prefit is made for a hollow synthetic stock, I dunno it you could cut the part that fits inside the stock off or not, best option would be to trace the butt and compare it to the master templates on their website, see the FAQs sticky above for recoil pad suggestions that may come close to fitting.

Tim

http://www.limbsaver.com/technical/templates.php

Logged
"Always do right, this will gratify some and astonish the rest" -  Mark Twain

Offline jbrray

  • Trade Count: (2)
  • Member
  • *
  • Posts: 35
Re: LimbSaver for thumbhole stock
« Reply #2 on: July 27, 2011, 03:33:48 AM »
Thanks for the link Tim, I'll see if I can match it up. I just figured that since there is a huge amount of tinkering that goes on with handis someone had already made the conversion.

JB
Logged
Pages: [1]   Go Up
« previous next »