« previous next »
Pages: [1]   Go Down

Author Topic: Looking for Detaled Drawing with Dimensions on a 3” Ordnance Rifle  (Read 372 times)

0 Members and 1 Guest are viewing this topic.

Offline BadBill

  • Trade Count: (0)
  • Posts: 1
Looking for Detaled Drawing with Dimensions on a 3” Ordnance Rifle
« on: September 21, 2011, 11:28:26 AM »
Looking for Detaled Drawing with Dimensions on a 3” Ordnance Rifle, I have a 4.5” OD x 3.125” ID x 66” Long, Hot Rolled, Seamless Steel Tube for a Barrel, I am looking to keeping the Barrel the same OD down the outside, and need dimensions for the Trunnions, and how far down the Barrel, and the Location and size of the Vent off the Breech.  Please Help if you can.
Thanks,
BadBill
Logged

Offline GGaskill

  • Moderator
  • Trade Count: (2)
  • Senior Member
  • *****
  • Posts: 5668
  • Gender: Male
Re: Looking for Detaled Drawing with Dimensions on a 3” Ordnance Rifle
« Reply #1 on: September 21, 2011, 12:35:35 PM »
Antique Ordnance Publishers is THE source for civil war era cannon plans.  You want No. 12.
Logged
GG
“If you're not a liberal at 20, you have no heart; if you're not a conservative at 40, you have no brain.”--Winston Churchill
Pages: [1]   Go Up
« previous next »