Author Topic: .22 hornet reduced loads  (Read 558 times)

0 Members and 1 Guest are viewing this topic.

Offline little bill

  • Trade Count: (0)
  • Member
  • *
  • Posts: 19
.22 hornet reduced loads
« on: October 21, 2011, 11:19:48 AM »
Is there any one that has used a reduced load in the hornet with jacketed bullets? I bought some .224 34gr. varmint nightmare bullets from midsouth shooters supply and they aren't vary consistant in my rifle. 4" groups at 100 yd. I would like to come down to .22 mag.vel. 2000 fps or less. As I have a large amt. of them,I thought I would use them on squirrls.    thanx!

Offline topper88

  • Trade Count: (5)
  • Member
  • *
  • Posts: 65
Re: .22 hornet reduced loads
« Reply #1 on: October 21, 2011, 12:23:15 PM »
Maybe your gun is too new and needs to be broken in.  I get sub minute of accuracy with the same bullet over 13 grains of Lil Gun but I use small pistol primer.  Small case, small powder load needs a smaller primer.  I learned this with my muzzle loader and 209 primers.  There is a thread on this topic somewhere.  With Lil Gun the pressure is much lower.  H110 was erratic in my gun also.

Offline Torwe

  • GBO Supporter
  • Trade Count: (33)
  • Avid Poster
  • *****
  • Posts: 180
  • Gender: Male
Re: .22 hornet reduced loads
« Reply #2 on: October 21, 2011, 12:39:02 PM »
My 22 mag clone load in the hornet is 3.5 gr Bullseye under a 40 gr jacketed hornady. Works really well.
Life is like a coin you can spend it any way you wish. But you can only spend it once.