« previous next »
Pages: [1]   Go Down

Author Topic: frame question  (Read 304 times)

0 Members and 2 Guests are viewing this topic.

Offline Jason F

  • Trade Count: (261)
  • Senior Member
  • *****
  • Posts: 2105
  • Gender: Male
frame question
« on: November 23, 2011, 05:11:41 AM »
If the maxi, 44 mag and 45-70 trap door loads are all suitable on Sb1 frame where does modern 38-55 reloads pressure operate at in comparison to the other three?
Logged
handi rifles- 22 mag      22 hornet    223      7mm-08      308 chip shot     30-30 x2     30-06 shorty      358 cheez whiz     357 max     35 remington     375-08    410 rifled slug     454 casull     460 s&w     45 smokeless muzzleloader x2     45-70    50 huntsman    50-70 government shikari     20 ga.ush     12 ga.ush    12 ga.3 1/2     10 ga.imp.cyl. slug gun

Offline quickdtoo

  • Global Moderator
  • Trade Count: (149)
  • Senior Member
  • *****
  • Posts: 43301
  • Gender: Male
Re: frame question
« Reply #1 on: November 23, 2011, 05:18:12 AM »
Less than 30-30 which is fine on SB1 frames, same case head, the SAAMI MAP is 30kcup, I think the old SAAMI MAP for the 30-30 was 38kcup before they updated to PSI.

Tim

http://www.leverguns.com/articles/saami_pressures.htm
Logged
"Always do right, this will gratify some and astonish the rest" -  Mark Twain
Pages: [1]   Go Up
« previous next »