« previous next »
Pages: [1]   Go Down

Author Topic: I fitted my 1st barrel  (Read 540 times)

0 Members and 1 Guest are viewing this topic.

Offline 3leggedturtle

  • Trade Count: (7)
  • Avid Poster
  • **
  • Posts: 209
  • Gender: Male
I fitted my 1st barrel
« on: November 26, 2011, 11:08:01 AM »
Kept looking at it and comparing both barrels,  finally took a file and a whetstone to it. only 12 strokes of the file, and 5 minutes with the whetstone. ;D   What is the next step/project i take towards being a handi-smith.  :)   3leg
Logged

Offline Jimbo47

  • GBO Supporter
  • Trade Count: (25)
  • Senior Member
  • *****
  • Posts: 1304
  • Gender: Male
Re: I fitted my 1st barrel
« Reply #1 on: November 26, 2011, 01:29:49 PM »
Next step would be checking the latch engagement by smoking the shelf, if you didn't already, and it's in the FAQ's also.
Good job!
Logged
My culled down Handi's are the 45-70, and then I have a few others to keep it company...357 Mag/Max. .45 LC/.454 Casull Carbine, .243 Ultra, and 20 gauge Tracker II.

Offline otterbob

  • GBO Supporter
  • Trade Count: (0)
  • Member
  • *****
  • Posts: 72
Re: I fitted my 1st barrel
« Reply #2 on: November 26, 2011, 02:35:51 PM »
If I understood the question correctly, next project might be slicking up the hammer/trigger.


Otter Bob
Logged

Offline 3leggedturtle

  • Trade Count: (7)
  • Avid Poster
  • **
  • Posts: 209
  • Gender: Male
Re: I fitted my 1st barrel
« Reply #3 on: November 27, 2011, 08:54:53 AM »
I fitted my 2nd barrel 45 minutes later. Now I just need to get to the range
 
Logged
Pages: [1]   Go Up
« previous next »