« previous next »
Pages: [1]   Go Down

Author Topic: 45acp questions  (Read 497 times)

0 Members and 1 Guest are viewing this topic.

Offline huntswithdogs

  • Trade Count: (1)
  • A Real Regular
  • ****
  • Posts: 999
45acp questions
« on: January 20, 2012, 04:05:27 AM »
I loaded my first ones the other day and have some questions/concerns.
My load was 5grs of Win231 behind a 180LSWC. Primer was a Win LP.

Some of my loads didn't burn all the powder, which surprised me. I had powder coming out of the cylinders when ejecting the shells.

I didn't think to check if it happened in just one cylinder, but I had a few of the rears of the shells dragging on the frame. I'd checked the case lengths before loading and rechecked them last nite. All are the same length. When they did this I pulled them back out to check the primers to make sure they weren't high. Didn't think until just now that it may have been powder...duh!

I think I crimped them enough, but I'm not totally sure. This taper crimp isn't as easy to check as the roll that I use for the 45LC. I'm gonna be loading some more tonite. Maybe I'll tighten it down a little more. I know on the Colt loads that the crimp can cause funny things to happen. If I didn't have it tight enough, could this have been the culprit causing some of the shells to drag?

All in All, I was pleased with the load. The shots all shot 6'' low and a little left at first. I tweeked the sites some and got them to come up on the target at least.

Thanks in advance,

HWD
Logged

Offline geezerbiker

  • Trade Count: (14)
  • Senior Member
  • *****
  • Posts: 1884
  • Gender: Male
Re: 45acp questions
« Reply #1 on: January 21, 2012, 01:32:37 AM »
I've shot a lot of rounds loaded with W231 and while it's a bit dirty, I've not had a problem with unburnt powder left in the case.  You may be on the right track with needing more crimp. 

It's also possible that there is some contaminate in the case.  Maybe from too much bullet lube but I'm only guessing here.  Off the top of my head 5 grains sounds a bit light, check your data and perhaps move toward the middle or upper end of the charge for this bullet.  Maybe a little more pressure will help burn all the powder.

I hope this helps...

Tony
Logged

Offline Lloyd Smale

  • Moderators
  • Trade Count: (32)
  • Senior Member
  • *****
  • Posts: 18273
Re: 45acp questions
« Reply #2 on: January 21, 2012, 01:37:02 AM »
bump the powder charge up a grain and see if it helps.
Logged
blue lives matter

Offline ButlerFord45

  • Moderators
  • Trade Count: (10)
  • Senior Member
  • *****
  • Posts: 1992
  • Gender: Male
Re: 45acp questions
« Reply #3 on: January 21, 2012, 02:48:12 AM »
Yep, light bullet and light load.  More crimp may help some but bumping up the powder charge will help with the burn. For me, it has never been a problem having a few unconsumed kernels/flakes left behind.
Logged
Butler Ford
He who does not punish evil, commands it to be done.-Leonardo da Vinci
An armed society is a polite society-Robert A. Heinlein
Only the dead have seen the end of war- Plato
Lord, make my words as sweet as honey
tomorrow I may have to eat them- A lady's sweatshirt

Offline cwlongshot

  • GBO Supporter
  • Trade Count: (158)
  • Senior Member
  • *****
  • Posts: 9907
  • Gender: Male
  • Shooting, Hunting, the Outdoors & ATVs
Re: 45acp questions
« Reply #4 on: January 21, 2012, 04:02:09 AM »
I agree, try a bit more powder.
Thats a light load, lighter than myown light load same powder same weight SWC bullet...
 
CW
Logged
"Pay heed to the man who carries a single shot rifle, he likely knows how to use it."

NRA LIFE Member 
Remember... Four boxes keep us free: the soap box, the ballot box, the jury box, and the cartridge box.

Offline huntswithdogs

  • Trade Count: (1)
  • A Real Regular
  • ****
  • Posts: 999
Re: 45acp questions
« Reply #5 on: January 21, 2012, 08:21:50 AM »
Thanks guys. I bumped the powder and improved my crimp a bit. I also checked to make sure these don't drag on the frame.
After comparing these to one I had left over from the last shoot, I found that my crimp was a little wimpy and lacking. We'll see what happens...

HWD
Logged

Offline ButlerFord45

  • Moderators
  • Trade Count: (10)
  • Senior Member
  • *****
  • Posts: 1992
  • Gender: Male
Re: 45acp questions
« Reply #6 on: January 21, 2012, 01:32:09 PM »
Hunts, Hunts, Hunts! The First Cardinal Rule of Load Develovment!!!!  Change only one (1) thing at a time!!    ::)
It is going to help and you will attest that it was the crimp and we're gonna be swearing it was the powder increase!  LOL   :o
Good Luck with the load.
 
BF
Logged
Butler Ford
He who does not punish evil, commands it to be done.-Leonardo da Vinci
An armed society is a polite society-Robert A. Heinlein
Only the dead have seen the end of war- Plato
Lord, make my words as sweet as honey
tomorrow I may have to eat them- A lady's sweatshirt

Offline noylj

  • Trade Count: (0)
  • Member
  • *
  • Posts: 26
  • Gender: Male
Re: 45acp questions
« Reply #7 on: January 21, 2012, 08:00:50 PM »
180gnL-SWCand5.0gn231isnotthatlightaload.
(Whydon'tmyMacsorPCsletmeusethespacekeyonthissite?)             
1)Areyoufullysizingthecases?ThecaseIDaftersizingshouldbeWELLUNDER0.450"               
2)Areyouexpandingthecaseproperly?     
ThecaseIDafterexpansionshouldbe0.449-0.450".
3)Afterseating, whatisthediameterofthebullet?         
4)Doyourroundspassthe"thumb"test?Pushthebulletintothebenchusingthumbpressure. TheCOLshouldnotchange.
       
Logged

Offline cwlongshot

  • GBO Supporter
  • Trade Count: (158)
  • Senior Member
  • *****
  • Posts: 9907
  • Gender: Male
  • Shooting, Hunting, the Outdoors & ATVs
Re: 45acp questions
« Reply #8 on: January 22, 2012, 09:30:47 AM »
Quote from: noylj on January 21, 2012, 08:00:50 PM
180gnL-SWCand5.0gn231isnotthatlightaload.
(Whydon'tmyMacsorPCsletmeusethespacekeyonthissite?)             
1)Areyoufullysizingthecases?ThecaseIDaftersizingshouldbeWELLUNDER0.450"               
2)Areyouexpandingthecaseproperly?     
ThecaseIDafterexpansionshouldbe0.449-0.450".
3)Afterseating, whatisthediameterofthebullet?         
4)Doyourroundspassthe"thumb"test?Pushthebulletintothebenchusingthumbpressure. TheCOLshouldnotchange.
     

OMG this hurts my brain!!! SPACING PLEASE!!!

At first I thought they where all links... Then maybe another language!! LOL

CW
Logged
"Pay heed to the man who carries a single shot rifle, he likely knows how to use it."

NRA LIFE Member 
Remember... Four boxes keep us free: the soap box, the ballot box, the jury box, and the cartridge box.

Offline tacklebury

  • GBO Supporter
  • Trade Count: (12)
  • Senior Member
  • *****
  • Posts: 3633
  • Gender: Male
  • Central Michigan
Re: 45acp questions
« Reply #9 on: January 22, 2012, 10:08:13 AM »
Thinking his keyboard is having issues see this one line:

Quote
Whydon'tmyMacsorPCsletmeusethespacekeyonthissite?

Do you have scroll lock on?
Logged
Tacklebury --}>>>>>    Multi-Barrel: .223 Superlite, 7mm-08 22", .30-40 Krag M158, .357 Maximum 16-1/4 HB, .45 Colt, .45-70 22" irons, 32" .45-70 Peeps, 12 Ga. 3-1/2 w/ Chokes, .410 Smooth slugger, .45 Cal Muzzy, .50 Cal Muzzy, .58 Cal Muzzy

also classics: M903 9-shot Target .22 Revolver, 1926 .410 Single, 1915 38 S&W Break top Revolver and 7-shot H&R Trapper .22 6" bbl.

Offline ButlerFord45

  • Moderators
  • Trade Count: (10)
  • Senior Member
  • *****
  • Posts: 1992
  • Gender: Male
Re: 45acp questions
« Reply #10 on: January 22, 2012, 11:43:37 AM »
Quote from: noylj on January 21, 2012, 08:00:50 PM
180gn L-SWC and 5.0gn 231 is not that light a load.

It is the starting load for the bullet, my limited experience with 231, it stays dirty till you get up around the max suggested loads.  Oh, they are probably not unburned, they are just unconsumed ash that will pretty much go away when the pressures increases.
Logged
Butler Ford
He who does not punish evil, commands it to be done.-Leonardo da Vinci
An armed society is a polite society-Robert A. Heinlein
Only the dead have seen the end of war- Plato
Lord, make my words as sweet as honey
tomorrow I may have to eat them- A lady's sweatshirt

Offline huntswithdogs

  • Trade Count: (1)
  • A Real Regular
  • ****
  • Posts: 999
Re: 45acp questions
« Reply #11 on: January 23, 2012, 10:57:37 AM »
Butler,

I don't usually do more than 1 "fix" at a time but I figured what the hey! If this works, fine. If it don't, we'll advance in a different direction the next go round. 1st chance I get, I'll let ya'll know what happened with my newest recipe.

Thanks again,
HWD
Logged
Pages: [1]   Go Up
« previous next »