« previous next »
Pages: [1]   Go Down

Author Topic: DIY rifle rear sight pusher design wanted  (Read 821 times)

0 Members and 1 Guest are viewing this topic.

Offline rdlange

  • GBO Supporter
  • Trade Count: (52)
  • Senior Member
  • *****
  • Posts: 1122
  • Gender: Male
DIY rifle rear sight pusher design wanted
« on: January 31, 2012, 05:48:45 PM »
Does anyone have a design for a homemade sight pusher that will work on a Handi rifle or Marlin. 

I already have punches, but they don't like me banging on my gun at the range.
Logged
Think as if you LIFE depends on it... IT does..!  Be Well...

Offline tacklebury

  • GBO Supporter
  • Trade Count: (12)
  • Senior Member
  • *****
  • Posts: 3633
  • Gender: Male
  • Central Michigan
Re: DIY rifle rear sight pusher design wanted
« Reply #1 on: February 01, 2012, 12:23:39 PM »
Don't know if it's an option for you, but Williams and others make sight pushers.  Some more and some less.  If it were me, I'd probably buy one.  If you want to make one, looks a lot like a c-clamp, so I'd say find a smaller c-clamp and modify to make it work.  If it were me, brass or aluminum would be better jaw choices than steel.  ;)
 
http://www.brownells.com/.aspx/pid=16152/Product/FRONT-SIGHT-PUSHER
Logged
Tacklebury --}>>>>>    Multi-Barrel: .223 Superlite, 7mm-08 22", .30-40 Krag M158, .357 Maximum 16-1/4 HB, .45 Colt, .45-70 22" irons, 32" .45-70 Peeps, 12 Ga. 3-1/2 w/ Chokes, .410 Smooth slugger, .45 Cal Muzzy, .50 Cal Muzzy, .58 Cal Muzzy

also classics: M903 9-shot Target .22 Revolver, 1926 .410 Single, 1915 38 S&W Break top Revolver and 7-shot H&R Trapper .22 6" bbl.

Offline Rangr44

  • Trade Count: (6)
  • Senior Member
  • *****
  • Posts: 2158
Re: DIY rifle rear sight pusher design wanted
« Reply #2 on: February 02, 2012, 12:18:33 PM »
AFAIK, there are no substitutes for moving a dovetail sight that's mounted directly in a barrel dovetail, other than a driftpin/hammer.
 
Commercial sight pushing tools are all designed to bear against the flat side of a sight ramp to move the sight blade.
 
.
Logged
There's a Place for All God's Creatures - Right Next to the Potatoes & Gravy ! !

Offline Airsporter

  • Trade Count: (8)
  • A Real Regular
  • ****
  • Posts: 893
  • Gender: Male
Re: DIY rifle rear sight pusher design wanted
« Reply #3 on: February 03, 2012, 11:14:18 AM »
I use my mini-mill.  I put masking tape on the vise jaws, tighten the slide in the vise, put a stud (usually an appropriate size drill bit - mounted upside down) in the chuck/collet, and use it to push sight in/out.  You could probably use a drill press with a compound vise - if it is big enough to take the lateral stress (can be pretty heavy).
 
Logged
Pages: [1]   Go Up
« previous next »