« previous next »
Pages: [1]   Go Down

Author Topic: Done my 1st trigger job  (Read 789 times)

0 Members and 1 Guest are viewing this topic.

Offline jake

  • Trade Count: (13)
  • Avid Poster
  • **
  • Posts: 171
Done my 1st trigger job
« on: March 09, 2012, 02:35:21 PM »
I just got done doing a trigger job on my Prohunter.I replaced the factory spring with a #3 aftermarket spring. All I can say is WHOA what a differance. :) :)
 
I thought it would be a little harder to do, but there is nothing to it.
Logged
jake

Offline edmehlig

  • Trade Count: (0)
  • Member
  • *
  • Posts: 21
Re: Done my 1st trigger job
« Reply #1 on: April 23, 2012, 02:10:33 AM »
Jake, where did you get your spring from and being not a gunsmith was it really that easy?  Did you need any special tools?
Logged

Offline DaddyPaul

  • Trade Count: (2)
  • Avid Poster
  • **
  • Posts: 180
Re: Done my 1st trigger job
« Reply #2 on: April 30, 2012, 12:58:26 AM »
Did you do any stoning on the parts or just swap springs?  Now that you've seen the insides of it the next time you taker her down will be even easier.  Congrats!
Logged
Pages: [1]   Go Up
« previous next »