« previous next »
Pages: [1]   Go Down

Author Topic: Timney Trigger on '98 mauser  (Read 953 times)

0 Members and 1 Guest are viewing this topic.

Offline lgm270

  • Trade Count: (1)
  • Senior Member
  • *****
  • Posts: 1862
Timney Trigger on '98 mauser
« on: May 04, 2012, 04:26:20 PM »
How tough is it to install a Timney trigger on a mil-surp '98 mauser? 


I'm fairly good with tools and tinkering, but have never tried this before.

Any help or experience appreciated.
Logged

Offline gunnut69

  • Moderators
  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 5005
Re: Timney Trigger on '98 mauser
« Reply #1 on: May 04, 2012, 05:11:22 PM »
It is literally a bolt on operation. Some actions may require a bit of filing for the trigger blade to clear the bottom metal. If a side safety is included clearance for the safety lever will have to be cut into the stock inlet..and that's likely the most difficult task! The stock may also require clearance if the inletting is especially tight to avoid the trigger making contact.
Logged
gunnut69--
The 2nd amendment to the constitution of the United States of America-
"A well regulated militia, being necessary to the security of a free state, the right of the people to keep and bear arms, shall not be infringed."

Offline Flemc1

  • Trade Count: (50)
  • Avid Poster
  • **
  • Posts: 175
  • Gender: Male
  • Gods Country North Idaho
Re: Timney Trigger on '98 mauser
« Reply #2 on: May 13, 2012, 10:40:10 AM »
Its a very simple surgery , I just done one on a 98 my very first , If you go to the Timney website there are detailed instructions , also they have a Techline . There will be instructions with the trigger , a Dremel tool is very helpfull . I had mine installed in less than an hour , that included inleting the stock .

Chris
Logged
U.S.Navy EN1  (ret)  Snipe.
Caught in the mix of kill or be killed ," Greater love have no man ".
Than to lay down his life for a Friend "
Pages: [1]   Go Up
« previous next »