« previous next »
Pages: [1]   Go Down

Author Topic: lawnmower moter  (Read 1230 times)

0 Members and 2 Guests are viewing this topic.

Offline srussell

  • GBO Supporter
  • Trade Count: (14)
  • A Real Regular
  • *****
  • Posts: 838
lawnmower moter
« on: June 03, 2012, 04:39:09 PM »
need help with a 8hp. Briggs cant get it to spark it will but very weak. has no points, i cleaned the flywheel and coil, new plug. I'm lost anyone help
Logged

Offline Empty Quiver

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 2847
Re: lawnmower moter
« Reply #1 on: June 04, 2012, 02:59:27 PM »
Quote from: srussell on June 03, 2012, 04:39:09 PM
need help with a 8hp. Briggs cant get it to spark it will but very weak. has no points, i cleaned the flywheel and coil, new plug. I'm lost anyone help
Something I would occasionally find is that where the plug wire exited the motor there was a break in the insulation that would allow it to nearly ground out, not all the way, but enough. I would wrap it with plenty of black tape and keep on going. These were 5hp pump motors (horizontal shaft). Best I got for you.
Logged
**Concealed Carry...Because when seconds count help is only minutes away**

Offline charles p

  • GBO Supporter
  • Trade Count: (1)
  • Senior Member
  • *****
  • Posts: 2374
  • Gender: Male
Re: lawnmower moter
« Reply #2 on: June 12, 2012, 02:16:22 PM »
My 5 year old B&S lawnmower motor was running poorly and surging.  I installed an Iridium Champion Plug (Easy Start) and it immediatly ran better than ever.  I use these plugs in all my small 2 and 4-stroke engines now.
Logged

Offline hillbill

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 3285
Re: lawnmower moter
« Reply #3 on: June 12, 2012, 02:28:56 PM »
if i remember rite, there is a certain tolerance that the flywheel shud be away from the coil measured with a feeler gauge. try that.
Logged

Offline hillbill

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 3285
Re: lawnmower moter
« Reply #4 on: June 12, 2012, 02:42:16 PM »
also try looking down in the fuel tank with a strong light to see if there is water in there. and crank it over and spray a bit of starting fluid in and see if it hits.
Logged

Offline Drilling Man

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 3636
Re: lawnmower moter
« Reply #5 on: June 21, 2012, 02:58:31 PM »
  I have an 8hp B&S motor on a compressor.  They only way i fixed the weak spark was to buy the whole ignition under the flywheel.  It now starts easily, like it did long ago EVERY TIME, with a strong spark!
 
  Very easy to install, and did the trick!
 
  DM
Logged

Offline Bugflipper

  • Trade Count: (6)
  • Senior Member
  • *****
  • Posts: 1849
  • Gender: Male
Re: lawnmower moter
« Reply #6 on: June 21, 2012, 07:36:17 PM »
If doing what the other fellows advised didn't work;
Electronic ignition conversions are pretty simple. I did one on a troybilt tiller that nothing would work on. It was just a little chip you wired into the ignition. It is a 1970's model with original motor. Did the conversion in the late 80's and it is still going. Here's one similar. http://www.killerbeezer.com/Ignition-ELECTRONIC_IGNITION_MODULE_NOVA_II.html
It just amplifies the spark. Guessing it's like a conversion for a car. Just that the magneto is the trigger instead.
Logged
Molon labe

Offline keith44

  • Trade Count: (2)
  • Senior Member
  • *****
  • Posts: 2748
  • Gender: Male
Re: lawnmower moter
« Reply #7 on: June 21, 2012, 08:12:16 PM »
yup sounds like something either in the pick up coil, or insulation breaking down on the plug wire

Logged
keep em talkin' while I reload
Life member NRA
Pages: [1]   Go Up
« previous next »